AEG 50212, 50612 manual Aqua Control, Open the porthole and extract the inlet hose

Page 31

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Important!

Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.

3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

4.Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

Installation should comply with local water authority and building regula- tions’ requirements.

A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe op-

eration of the appliance.

If you cannot make the cold water

connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Aqua Control

The inlet hose is provided with a wa- ter stop device, which protects against damage caused by water leaks in the hose which could devel- op due to natural ageing of the hose. This fault is shown by a red sector in the window „A”. Should this occur, turn the water tap off and re- fer to your Service Centre to replace the hose.

31

Image 31
Contents Lavamat 50212/50612 Dear customer Following symbols are used in the textContents Installation and connection instructions Follow the Instructions for installation and connection SafetyPrior to using for the first time Child safetyThis could constitute a fire hazard through overheating General safetyControl Panel Description of the applianceProgramme Programme overviewApplication/Features Care Sorting washing Before the first washPreparing and sorting washing Preparing washingFor USA and Canada only Running a washing cycleOpening the door/Loading the washing Adding detergent/additivesIf you use liquid detergents Washing powder/tablets for the main washChanging the spin speed/Selecting rinse hold Switching on the appliance/selecting a programmeDeactivating RINSE+ Selecting programme optionsActivating/deactivating RINSE+ Activating RINSE+Interrupting a programme Setting the delay timerStarting a programme Interrupting a programme/adding washingIf Rinse Hold was selected End of the wash programme/Removing the washingReleasing the child safety device Child safety deviceCleaning and maintenance Cleaning procedureWashing drum Detergent dispenser drawerDoor and rubber collar Remedying minor malfunctions yourself What to do ifOnly a few large items After the last rinse foam can still be seen If the wash results are not satisfactoryWashing is grey and scale is being deposited in the drum There are grey stains on the washingCarrying out an emergency drain When the water has all drained awayDrain pump Packaging material DisposalOld appliance Consumption values Technical dataInstalling the appliance Safety information for the installationTransporting the appliance Unpacking When moving using a sack trolleyPage Where to install Permitted water pressure Connecting to the water supplyElectrical connection Making the appliance levelOpen the porthole and extract the inlet hose Aqua ControlPumping heights over 1 m Water drainageDraining water into a wash basin/bath Guarantee/Customer Service Service & Repair User Instructions & Installation ManualService 132 975 Subject to change without notice