|
|
|
| 132996260.qxd 7/24/01 9:12 PM Pagina 45 | (Nero/Process Black pellicola) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Installation
Water inlet (cold water connection only)
Connect the hose
to a tap with a 3/4” thread.
Installation
should comply with local water authority and
building regula- tions’ require- ments.
Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in
the window “A”. Should this occur, turn the A water tap off and refer to your Service Force Centre to replace the hose.
Water drainage
The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic
When discharging into a stand- pipe ensure that the top of the curve in the hose end is no more than 90 cm (35.4”) and no less than 60 cm (23.6”) above floor level.
3 pin
Max. 90 cm.(35.4")
Min.60 cm.(23.6")
45