Prima LPR 712 manual Emergency emptying out, Water inlet filter

Page 17

Unscrew and remove the filter.

The dangers of freezing

P0037

P0039

If the machine is exposed to temperatures below 0°C, certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Unhook the drain hose from the rear support and

 

position the end of this hose and that of the inlet

 

hose in a bowl. Run the draining programme.

Disconnect the appliance.

Screw the inlet hose and reposition the drain hose.

Clean carefully under a fast running tap.

P0040

Warning

When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it.

The water inlet filter

If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to time. Turn off the water tap. Unscrew the water inlet hose. Clean the filter using a hard bristle brush.

Tighten up the inlet hose.

P1090

When you intend to start the machine up again,

make sure that the room temperature is above 0°C.

Important!

Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run “Drain” programme. This will activate the ECO valve and avoid the detergent remains being wasted.

Emergency emptying out

If the water is not discharged, proceed as follows to empty out the machine:

pull out the plug from the power socket;

close the water tap;

if necessary, wait until the water has cooled down;

Unscrew and remove the filter;

place a bowl on the floor. The water should drain by gravity into the bowl. When the bowl is full, empty the bowl. Repeat the procedure until water stops flowing out;

clean the filter if necessary as previously described;

screw the filter again.

17

Image 17
Contents Washing Machine Use InstallationChild Safety Contents Interest of the environment Your New Washing MachineEcological hints Description of the Appliance Child safety featureDetergent dispenser drawer Prewash Main wash Fabric softener1Detergent dispenser drawer Mains-on light Control PanelOn/Off button Spin buttonExtra Rinse button Prewash buttonEasy Iron button Start/Pause buttonAltering an option or a running programme Programme informationInterrupting a programme Opening the door after the programme has startedLoad the laundry Switch the machine onOperating Sequence Start the programme Select the required optionsAt the end of the programme Turn the programme selector dial to the desired position1000g = 1 kg Washing HintsWhich form? Which detergent?Important Notes Wash Care SymbolsWashing Programmes Min Soak Special ProgrammesMaintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working Symptom Possible causes Service & Spare Parts0870 5 Customer Care DepartmentStandard guarantee conditions Guarantee ConditionsEuropean guarantee This guarantee does not coverTechnical Specifications Installation InstructionsPositioning UnpackingWater inlet Appliance must be connected to a cold water supplyJoining piece must have an internal diameter of 18mm Water drainageInto a drainage standpipe StandpipeSpecial conditions LevellingBlue- Neutral Brown- Live Electrical connectionPermanent connection Building-in Preparation and assembly of the doorFront view Plc