Prima LPR 712 manual Front view

Page 27

 

6

 

4

P0984

D

 

If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate

(5)(Fig. B and E). Mount the countermagnet (6) and the hinges (1) as previously described.

 

 

 

E

4

 

 

6

 

 

 

 

5

7

1

 

 

 

 

 

 

 

3

 

P0983

 

 

2

 

 

 

Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised

Where the appliance has been raised by mounting onto a wooden base provided by the installer. The material used to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.

If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the underside of the base (see Fig. F).

Drill four fixing holes see Fig. G

 

600-605 mm

 

490 mm

 

95 mm

 

Front edge

 

50 mm

G

Top view

 

Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow.

The reason for placing the base in this position is to allow a small strip of beading to be fitted in front of the appliance feet.

Fix the base firmly to the floor using four appropriate countersunk screws (see Fig. H).

Hardwood strip

5 X 25 X 605

5 mm x 25 mm

490

 

600-605

H

With the appliance installed adjust all four feet ensuring the machine is stable, and a clearance of approximately 5 mm is left between the top of the machine and the underside of the worktop.

A final check for stability should be carried out with the machine on spin with a load, this will identify the need for any further fine adjustment to the feet.

A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be screwed down into the base directly in front of the machine’s feet, this will provide

5 mm Hardwood strip

40 mm

100mm

600-605 mm

Additional pieces of timber should run from front to back

additional security.

If required an additional door magnet, part number 1242394-00/3 and disc, part number 1242393-00/5 are available from spare parts.

F

Front view

27

Image 27
Contents Washing Machine Installation Child SafetyUse Contents Your New Washing Machine Ecological hintsInterest of the environment Prewash Main wash Fabric softener Child safety featureDescription of the Appliance Detergent dispenser drawerSpin button Control Panel1Detergent dispenser drawer Mains-on light On/Off buttonStart/Pause button Prewash buttonExtra Rinse button Easy Iron buttonOpening the door after the programme has started Programme informationAltering an option or a running programme Interrupting a programmeSwitch the machine on Operating SequenceLoad the laundry Turn the programme selector dial to the desired position Select the required optionsStart the programme At the end of the programme1000g = 1 kg Washing HintsWhich form? Which detergent?Important Notes Wash Care SymbolsWashing Programmes Min Soak Special ProgrammesMaintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working Customer Care Department Service & Spare PartsSymptom Possible causes 0870 5This guarantee does not cover Guarantee ConditionsStandard guarantee conditions European guaranteeTechnical Specifications Installation InstructionsAppliance must be connected to a cold water supply UnpackingPositioning Water inletStandpipe Water drainageJoining piece must have an internal diameter of 18mm Into a drainage standpipeSpecial conditions LevellingElectrical connection Permanent connectionBlue- Neutral Brown- Live Building-in Preparation and assembly of the doorFront view Plc