Prima LPR 712 manual Electrical connection, Permanent connection, Blue- Neutral Brown- Live

Page 25

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

 

Mod

 

Prod. No

P0042 BD

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely. Should the appliance power supply cable neeed to be replaced, this MUST be carried out by our Service Force Centre.

Note

When the appliance is installed the power supply cable must be accessible.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

N

13 A

L

BROWN

BLUE

P1041

CORD CLAMP

 

25

Image 25
Contents Washing Machine Child Safety InstallationUse Contents Ecological hints Your New Washing MachineInterest of the environment Description of the Appliance Child safety featureDetergent dispenser drawer Prewash Main wash Fabric softener1Detergent dispenser drawer Mains-on light Control PanelOn/Off button Spin buttonExtra Rinse button Prewash buttonEasy Iron button Start/Pause buttonAltering an option or a running programme Programme informationInterrupting a programme Opening the door after the programme has startedOperating Sequence Switch the machine onLoad the laundry Start the programme Select the required optionsAt the end of the programme Turn the programme selector dial to the desired position1000g = 1 kg Washing HintsWhich form? Which detergent?Important Notes Wash Care SymbolsWashing Programmes Min Soak Special ProgrammesMaintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working Symptom Possible causes Service & Spare Parts0870 5 Customer Care DepartmentStandard guarantee conditions Guarantee ConditionsEuropean guarantee This guarantee does not coverTechnical Specifications Installation InstructionsPositioning UnpackingWater inlet Appliance must be connected to a cold water supplyJoining piece must have an internal diameter of 18mm Water drainageInto a drainage standpipe StandpipeSpecial conditions LevellingPermanent connection Electrical connectionBlue- Neutral Brown- Live Building-in Preparation and assembly of the doorFront view Plc