Schumacher PID-200 owner manual Troubleshooting

Page 8

TROUBLESHOOTING

PROBLEM: Alarm is On

Reason/Solution

1.Device has a short circuit or demands too much surge power.

Cycle inverter power OFF and ON.

If problem persists, use a larger inverter or a smaller device.

Remove defective device.

See warranty and call Customer Service 800-621-5485

(Hours: 7 a.m. – 4:30 p.m. CST).

2.Inverter shuts down.

12 Volt battery too low. Recharge/replace low battery.

3.Display shows Input Voltage between 10.7 and 11.3 Volts.

12 Volt battery is low. Recharge/replace low battery.

4.12 Volt voltage is too high.

If in a vehicle, repair/replace the alternator or charging system.

Use a properly sized and rated 12 Volt battery.

8

Image 8
Contents Includes 12 Volt Accessory Plug with 36 Cable and USB Port Important Safety Instructions Before Using PID-200 power Inverter Wash hands after handlingHow to use the 12 Volt Accessory Plug Operating InstructionsHow to use the USB Port Power SourceUsage Examples Device Type Estimated WattageDigital display Troubleshooting Device demands more than 200 Watts continuous power Problem Inverter Does Not Turn OnPower consumed by load may be too high Inverter is too hotProblem Keeps Blowing Fuses SpecificationsLimited Warranty
Related manuals
Manual 24 pages 63.78 Kb