Smeg WLB500T manual

Important

Before putting the machine into use, don't forget to remove the transport brackets. Switching on a blocked machine may damage the machine. Our guarantee does not cover such damage.

•Before switching the machine on, check that the transport brackets has been removed.

•Don't place the appliance in a room where the temperature may fall bellow 0°C, causing individual parts of the machine to freeze and become damaged (hose may crack).

•The appliance should stand firmly and horizontally on a solid base (a machine standing on an uneven floor is very likely to vibrate during the spinning cycle).

•Always consider the instructions for correct placing and installation of the machine to the mains and water supply. This will help you avoid accidents and protect your machine against damage.

•The appliance is to be connected to the water mains using new hose-sets and that old hose- sets should not be reused.

•The appliance my not be built-in under the kitchen worktop in a row of cabinets, because the use of the appliance without the top cover is not allowed for safety reasons. Likewise, the removal of the rear panel and the bottom of the appliance are also not allowed.

•The appliance should be positioned in such way to provide normal ventilation.

•The end of the outlet hose should not be immersed in the discharge water (the machine may pump the discharge water back).

•During the washing cycle, the door of the machine cannot be opened. It can only be opened 2 minutes after washing is finished.

•The glass door gets very hot during washing, so take care of children.

•Use only washing powder and other agents specially designed for machine washing.

We do not take any responsibility for damage caused by the improper use of bleaching or colouring agents (coloured gasket and other plastic parts).

•Lime dissolving agents contain acid, so only use those containing rust-protection agents. Always consider the manufacturer's instructions. When you have finished removing lime deposit, run a few rinse cycles to make sure that the acid is thoroughly rinsed. Even traces of acid can cause substantial damage to component parts.

•Never use washing agents containing solvents - individual component parts may be damaged or toxic gases may be produced. There is also a risk of ignition or explosion.

•When washing is finished, remember to close the tap.

•Your washing machine can only be transported with transport brackets. It is usually enough to use only one of the rods, that is the upper one. It is much easier to insert the rod if you remove the top cover. Before doing anything, however, don't forget to disconnect the machine from the power supply.

•Data plate with essential information on the appliance is fitted above the opening for laundry insertion under the door frame.

Instructions for Use 53