Removing the Transport Brackets
The washing assembly is blocked with two metal rods which protect the machine during transport (fig.1).
•Undo the screws on the rear wall (fig. 2).
•Remove the squares, rotate them 180° and use them to pull out the rods (fig. 3).
•Disengaged parts may remain at the bottom since they do not obstruct the operation of the machine (4 rubber hoses and 4 paper spools).
•Use the enclosed plastic caps to plug the holes (fig. 4).
1 |
3 |
2 |
4 |
Save the brackets: you may need them later.
54 | Instructions for Use |