Beko User's Manual WM 95135 LB WM 95145 LW user manual Troubleshooting, 34 / 40 EN

Page 34

Troubleshooting

Washing takes longer time than specified in the manual.(*)

•Water pressure is low. >>> Machine waits until taking in adequate amount of water to prevent poor washing quality due to the decreased amount of water. Therefore, the washing time extends.

•Voltage might be low. >>> Washing time is prolonged to avoid poor washing results when the supply voltage is low.

•Input temperature of water might be low. >>> Required time to heat up the water extends in cold seasons. Also, washing time can be lengthened to avoid poor washing results.

•Number of rinses and/or amount of rinse water might have increased. >>> Machine increases the amount of rinse water when good rinsing is needed and adds an extra rinsing step if necessary.

•Excessive foam might have occurred and automatic foam absorption system might have been activated due to too much detergent usage. >>> Use recommended amount of detergent.

Programme time does not countdown. (On models with display)(*)

•Timer may stop during water intake. >>> Timer indicator will not countdown until the machine takes in adequate amount of water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer indicator will resume countdown after this.

•Timer may stop during heating step. >>> Timer indicator will not countdown until the machine reaches the selected temperature.

•Timer may stop during spinning step. >>> Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum.

Programme time does not countdown.(*)

•There might be an imbalance of laundry in the machine. >>> Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum.

Machine does not switch to spinning step.(*)

•There might be an imbalance of laundry in the machine. >>> Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum.

•The machine will not spin if water is not drained completely. >>> Check the filter and the draining hose.

•Excessive foam might have occurred and automatic foam absorption system might have been activated due to too much detergent usage. >>> Use recommended amount of detergent.

Washing performance is poor: Laundry turns gray.(**)

•Insufficient amount of detergent was used over a long period of time. >>> Use the recommended amount of detergent appropriate for water hardness and the laundry.

•Washing was made at low temperatures for a long time over a long period of time. >>> Select the proper temperature for the laundry to be washed.

•Insufficient amount of detergent is used with hard waters. >>> Using insufficient amount of detergent with hard water causes the soil to stick on the cloth and this turns the cloth into gray in time. It is difficult to eliminate graying once it happens. Use the recommended amount of detergent appropriate for water hardness and the laundry.

•Too much detergent is used. >>> Use the recommended amount of detergent appropriate for water hardness and the laundry.

34 / 40 EN

Washing Machine /User’s Manual

 

 

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Washing Machine Dear Customer Explanation of symbols Important information or useful hints about usageMaintenance and cleaning Important instructions for safety Environment4Installation TroubleshootingUnplug the product when not in use Important instructions for safety and environmentGeneral safety Service life of your product is 10 yearsDisposing of the waste product Package informationCompliance with Weee Directive This appliance’s packaging material isOverview Power cableYour washing machine Top panel Loading door Control panelYour washing machine Package Contents Stand-by mode power W Off-mode power W Main model code Your washing machine Technical specificationsTotal current a Total power W 2200 Spin speed rpm max Single Water inlet / Double Water inlet AvailableRemoving packaging reinforcement InstallationAppropriate installation location Removing the transportation locksConnecting to the drain InstallationConnecting water supply InletAdjusting the feet 11 / 40 ENFitting a different plug Installation Electrical connection12 / 40 EN 13 / 40 EN Sorting the laundry Preparation14 / 40 EN Things to be done for energy saving Preparation Preparing laundry for washingInitial use 15 / 40 ENPreparation Correct load capacity Using detergent and softenerLoading the laundry Use different detergents for coloured and white laundry Adjusting detergent amountPreparation 17 / 40 ENDo not use softener and starch together in a washing cycle Using starchUsing bleaches Do not use bleaching agent and detergent by mixing themPreparation Tips for efficient washing 19 / 40 ENControl panel Display symbolsOperating the product On / Off buttonMain programmes Operating the product Preparing the machineProgramme selection Additional programmesOperating the product Special programmes23 / 40 EN Temperature selectionSpin speed selection Use a lower spin speed for delicate laundriesProgramme and consumption table 24 / 40 ENExtra Rinse Operating the product Auxiliary function selectionPrewash 25 / 40 ENCancelling the Delayed Start function Delayed startChanging the delayed start period Time displayLoading door lock Operating the product Starting the programmeProgress of programme Changing the selections after programme has startedChild Lock Cancelling the programmeMachine is in Rinse Hold mode End of programmeQuick User Guide 29 / 40 EN30 / 40 EN Cleaning the detergent drawerCleaning the loading door and the drum MonthsCleaning the body and control panel Maintenance and cleaningCleaning the water intake filters Draining remaining water and cleaning the pump filterPull the emergency draining hose out from its seat Install the filter32 / 40 EN Programme cannot be started or selected Troubleshooting33 / 40 EN Machine does not fill with waterTroubleshooting 34 / 40 EN35 / 40 EN It does not rinse wellWater pressure is low. Check the water pressure 36 / 40 ENDetergent residue in the detergent drawer Foam is overflowing from the detergent drawer37 / 40 EN On / Off button might not be pressed. Press On / Off buttonLoading door may be open. Close the loading door Machine does not start. Nothing appears on the displayComplying Commission Delegated Regulation EU No 1061/201 38 / 40 ENService Washing MachinesGuarantee Washing Machines, Dishwashers and Electric Cookers
Top Page Image Contents