No water can be seen in the machine during washing.
CThe water level is not visible from outside of the washing machine. This is not a
failure.
Loading door cannot be opened.
•Door lock is activated because of the water level in the machine. >>> Drain the water by running the Pump or Spin programme.
•Machine is heating up the water or it is at the spinning cycle. >>> Wait until the programme completes.
•Child lock is engaged. Door lock will be deactivated a couple of minutes after the programme has come to an end. >>> Wait for a couple of minutes for
deactivation of the door lock.
Washing takes longer time than the one specified in the manual.
•Water pressure is low. >>> Machine waits until taking in adequate amount of water to prevent poor washing quality due to the decreased amount of water. Therefore, the washing time extends.
•Voltage might be low. >>> Washing time is prolonged to avoid poor washing results when the supply voltage is low.
•Input temperature of water might be low. >>> Required time to heat up the water extends in cold seasons. Also, washing time can be lengthened to avoid poor washing results.
•Number of rinses and/or amount of rinse water might have increased. >>>
Machine increases the amount of rinse water when good rinsing is needed and adds an extra rinsing step if necessary.
•Excessive foam might have occurred and automatic foam absorption system might have been activated due to too much detergent usage. >>> Use recommended amount of detergent.
CMachine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the machine and to its
surrounding environment. Laundry should be rearranged and
•Timer may stop during water intake. >>> Timer indicator will not countdown until the machine takes in adequate amount of water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water.
Timer indicator will resume countdown after this.
•Timer may stop during heating step. >>> Timer indicator will not countdown until the machine reaches the selected temperature.
•Timer may stop during spinning step. >>> Automatic unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the drum.
CMachine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the machine and to its surrounding environment. Laundry should be rearranged and
59
EN