If the filter cap is one piece, pull the cap from both sides at the top to open.
CYou can remove the filter cover by slightly pushing downwards with a thin plastic tipped tool, through the gap above the filter cover. Do not use metal tipped tools to remove the cover.
3.Some of our products have emergency draining hose and some does not have. Follow the steps below to discharge the water.
Discharging the water when the product has an emergency draining hose:
a.Pull the emergency draining hose out from its seat
b.Place a large container at the end of the hose. Drain the water into the container by pulling out the plug at the end of the hose. When the container is full, block the inlet of the hose by replacing the plug. After
the container is emptied, repeat the above procedure to drain the water in the machine completely.
c.When draining of water is finished, close the end by the plug again and fix the hose in its place.
d.Turn the pump filter to take it out.
Discharging the water when the product does not have an emergency draining hose:
a.Place a large container in front of the filter to catch water from the filter.
b.Loosen pump filter (anticlockwise) until water starts to flow. Fill the flowing water into the container you have placed in front of the filter.
Always keep a piece of cloth handy to absorb any spilled water.
c.When the water inside the machine is finished, take out the filter completely by turning it.
4.Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5.Install the filter.
AIf your product has a water jet feature, be sure to fit the filter into its housing in the pump. Never force the filter while installing it into its housing. Seat the filter into its place completely. Otherwise, water may leak from the filter cap.
6.If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat the tabs in the lower part into
56 
EN