ENGLISH | 21 |
•place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the pro- cedure until water stops flowing out;
•clean the pump if necessary as previously described;
•replace the emergency emptying hose in its seat after having plugged it;
•screw the pump cover again and close the door.
What to do if…
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (re- fer to the table). If not, contact the service centre.
With some problems, the acoustic signals operate and the display shows an alarm code:
• 
- The appliance does not fill with wa-
•- The appliance does not drain the water.
•- The appliance door is open or not closed correctly.
ter.
Warning! Switch off the appliance before you do the checks.
Problem | Possible cause | Solution |
| The water tap is closed. | Open the water tap. |
| The inlet hose is squashed or | Check the inlet hose connection. |
| kinked. |
|
| The filter in the inlet hose or the inlet | Clean the water inlet filters. (See |
| valve filter are blocked. | "Cleaning the water inlet filters" for |
The appliance |
| more details). |
does not fill: | The water tap is blocked or is furred | Clean the water tap. |
| with limescale. |
|
| The connection of the water inlet | Check the inlet hose connection. |
| hose is not correct. |
|
| The water pressure is too low. | Contact your local water authority. |
| The door is not properly closed. | Close the door firmly. |
|
|
|
| The drain hose is squashed or | Check the drain hose connection. |
The appliance | kinked. |
|
does not drain | The drain filter is clogged. | Clean the drain filter. |
the water: |
|
|
The connection of the drain hose is | Check the drain hose connection. | |
| not correct. |
|