John Lewis JLWM1403 Delay start button, Selecting the delayed start, Cancelling the delayed start

•“Prewash”: select this option if you wish your laundry to be prewashed before the main wash (not available for Wool and “30 Minute wash”). The prewash ends with a short spin at 650 rpm in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. This option can be selected for heavily soiled laundry but not together with “Stain” option.

•“Intensive”: this option can be selected for heavily soiled cottons and synthetic. If you depress this button the washing intensity will be increased and the washing time will be prolonged by few minutes depending on the selected temperature and type of fabric.

This option is not available for “Economy” programmes, Wool, Delicates and “30 Minute wash” programmes.

•“Stain”: select this button if you wish to add to the

washing of heavy soiled laundry a stain phase: at the

temperature of 40°C pour a stain removing detergent into the compartment marked .

This function is available in cotton and synthetic programmes with a temperature of 40° or higher.

The washing time will be prolonged by few minutes. The “Prewash” and the “Stain” options cannot be selected together.

•“Extra rinse”: this option can be selected with all programmes, except the wool programmes and “30 Minute wash”. The machine will add 2 rinses to the selected programme.

This option is recommended for people who are allergic to detergents, and areas where the water is very soft.

•“Quiet”: when you choose this option, the machine will not drain the water of the last rinse, this will ensure the minimum of creasing to laundry.

As all spinning phases are cancelled, this washing cycle is very quiet and it can be useful at night or in hours with more economical power rate.

The machine will perform 3 additional rinses on cottons and 1 additional rinse on synthetics programmes.

At the end of the cycle, the light corresponding to the option “Quiet” and the “Rinse hold” pilot phase light are on, the “Start/Pause” button light goes out, the door locked light is on and the door cannot be opened to indicate that the water must be drained.

A blinking zero will appear on the display.

To empty out water there are 2 possibilities:

-Select “Drain” programme :

the water is emptied out without spinning.

-Select the “Spin” programme. Select the spin speed by means of the relevant button and then depress the “Start/Pause” button . The water is emptied out and the laundry is spun at the selected spin speed.

Attention!

Before selecting “Drain” programme or “Spin” programme the selector dial must to be positioned on “Off”.

5 Delay start button

This button makes it possible to delay the starting of the programme from 30 min – 60 min – 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.

The Delay start cannot be selected with “Soak 30°”, “Drain” and “Spin” programmes.

Selecting the delayed start

You must select this option after you have set the programme and before you press the Start/Pause button.

The machine starts its countdown. The programme will start after the selected delay has expired.

Cancelling the delayed start

If you have already pressed the Start/Pause button, and you wish to cancel the delay time, proceed as follows:

•set the washing machine to Pause by pressing the Start/Pause button;

•press the “Delay start” button until the display shows the symbole «0’».

•press the “Start/Pause” button again.

Important!

The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to Pause by pressing the Start/Pause button. After you have closed the door, press the Start/Pause button again.

12