Basket crooked
•Was the washer basket pulled forward during loading? Push the basket to the center before starting wash.
•Is the load balanced and the washer level? The wash load should be balanced and not overloaded. The washer must be level. The front feet should be properly installed and the nuts tightened. Reset the rear leveling legs (if needed). See the Installation Instructions.
•The washer basket moves while washing. This is normal.
Agitator operation
•The top of the agitator is loose, or moves in only one direction. This is normal.
Washer stops, won't fill, rinse or agitate
•Checkthe following:
Is the power cord plugged into a grounded 3 prong outlet?
Is the indicator on the Cycle Control knob properly lined up with a cycle? Turn the Cycle Control knob to the right slightly and pull to start.
Are the water inlet valve screens clogged?
Are both the hot and cold water faucets turned on? Is the water inlet hose kinked?
•Is the lid open? The lid must be closed to operate.
•Does the water level seem too low, or does the washer appear to not fill completely? The top of the agitator is much higher than the highest water level. This is normal and necessary for clothes to move freely.
•Has a fuse blown or is the circuit breaker open? If problem continues, call an electrician.
•Are you using an extension cord? Do not use an extension cord.
•Is the washer overloaded? Wash smaller loads.
Washer won't drain or spin
•Is the drain hose clogged, or the end of the drain hose more than 96 in. (244 cm) above the floor? See the Installation Instructions for proper installation of drain hose.
•Is the lid open? The lid must be closed to operate.
Is there excessive sudsing? Always measure detergent. Follow manufacturer's directions.
Washer continues to fill or drain, cycle seems stuck
Is the top of drain hose lower than the water level in washer? The top of the hose must be higher than the water
level in the washer for proper operation. See the Installation Instructions.
Does the drain hose fit too tightly in the standpipe, or is it taped to the standpipe? The drain hose should be loose yet fit securely. Do not seal the drain hose with tape. The hose needs an air gap. See the Installation Instructions.
Wash temperature not what I selected
•Are the hot and cold water inlet hoses reversed? See the Installation Instructions for more information. As your frequency of loads washed increases, the water temperature may decrease for hot and warm temperature selections. This is normal.
NEW VEND PRICE
To change vend price, detach and mail the lower portion to:
Customer Service Department
Greenwald Industries Inc.
212 Middlesex Ave.
Chester, CT 06412
The coin chute has been
When increasing in $.25 pricing
Follow product information instructions; no extra parts required.
When decreasing in $.25 pricing - or - changing to $.10 pricing
(Coin sizing block required; see "Changing Vend Price" section.)
Order required parts using this
Quantity
Existing Vend Price
New Vend Price
Name
Company
Address
City
Daytime phone
Purchase date
14