Kenmore 3948597B manual Alternate Parts, If You Have You Will Need to Buy, You will need

Alternate Parts

Parts listed are available from your local Sears store or Sears Service Center. Please reference the service numbers located on

the back page of this manual.

If You Have:		You Will Need to Buy:
_j_,_	_,_ _
Floor	drain	Siphon	break, Part Number 285320;
		additional drain hose, Part Number
		3357090 and connector kit,
		Part Number		285442
Drain	hose too	Drain hose,		Part No. 285442
short
Change Vend		Up to 7 quarters and 1 dime,			Part
Price	*	Number	29-3067
		Up to 8 quarters and 0 dimes, Part
		Number	26-3066
Gearcase		SAE60	Non-Detergent, Non-Foaming
Lubricant		Motor oil, 1 pint, Part Number			350572

•Unless otherwise ordered, all coin chutes are supplied with Part 20-3006 in place.

Selecting the proper location for your washer improves performance and minimizes noise and possible washer "walk."

Your washer can be installed in a basement, laundry room, closet, or recessed area. (See "Drain System.")

IMPORTANT: Do not install or store the washer where it will be exposed to the weather.

Proper installation is your responsibility.

You will need:

•A water heater set to deliver 120°F (49°C) water to the washer

A grounded electrical outlet located within 4 ft (1.2 m) of where the power cord is attached to the back of the washer. (See "Electrical Requirements.")

Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of

10-190 psi (34.5-696 kPa). 20-196 psi (138-696 kPa) for best performance.

A level floor with a maximum slope of 1 in. (2.5 cm) under

entire washer. Installing the washer on carpeting is not recommended.

•A sturdy floor to support the washer weight (washer, water and load) of 315 Ibs (143 kg).

Do not store or operate your washer in temperatures at or below 32°F (9°C). Some water can remain in the washer and can cause

damage in low temperatures. See "Washer Care" in the Washer User Instructions for winterizing information.

_,_, _;_1 _!_d_!:;_'_;;_;

The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain

system. Select the drain hose installation method you need. See "Alternate Parts."

N =

L

2

Standpipe drain system - wall or floor (view I & 2)

The standpipe drain requires a minimum diameter standpipe of 2 in. (5 cm). The minimum carry-away capacity can be no less than 17 gal. (64 L) per minute.

The top of the standpipe must be at least 39 in. (99 cm) high and no higher than 96 in. (244 cm) from the bottom of the washer.

Laundry tub drain system (view 1)

The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 39 in. (99 cm) above the floor and no higher than 96 in. (244 cm) from the bottom of the washer.

Floor drain system (view 2)

The floor drain system requires a siphon break that may be purchased separately. See "Alternate Parts."

The siphon break must be a minimum of 28 in. (71 cm) from the bottom of the washer. Additional hoses might be needed.

4