Connect the inlet hoses to the water faucets

1.Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings.

1.Coupling

2.Washer

Connect the inlet hoses to the water faucets

Make sure the washer basket is empty.

2.Attach the hose with the red coupling to the hot water faucet. Screw on coupling by hand until seated on the washer.

3.Attach the hose with the blue coupling to the cold water

faucet. Screw on coupling by hand until seated on the washer.

4.Using pliers, tighten the couplings with an additional two- thirds turn.

NOTE: Do not overtighten. Damage to the valves can result.

Clear the water lines

5.Run water through both faucets and inlet hoses, into a bucket or laundry tub, to get rid of particles in the water lines that might clog the inlet valve screens.

Connect the inlet hoses to the washer

6.Attach the hose with the red coupling to the HOT (bottom) inlet valve. Attaching the red coupling first makes it easier to tighten connection with pliers. Screw on coupling by hand until seated on the washer. Using pliers, tighten the couplings with an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the valves can result.

1.Cold water inlet valve (blue)

2.Hot water inlet valve (re@

NOTE: The inlet valve may be on the right or the left side of the washer, depending on your model.

7.Attach the hose with the blue coupling to the COLD water (top) inlet valve. Screw on coupling by hand until seated on the washer. Using pliers, tighten the couplings with an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the valves can result.

Check for leaks

8.Turn on the water faucets and check for leaks. A small

amount of water might enter the washer. You will drain this later.

NOTE: Replace inlet hoses after 5 years of use to reduce the

risk of hose failure. Record hose installation or replacement dates for future reference.

If you connect only one water hose, you must cap off the remaining water inlet port.

Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.

1, Drape the power cord over the console.

2, Remove any cardboard used to move washer,

3, Locate the remaining portion of shipping strap (not the end with the cotter pins) from step 3 of "Remove Shipping Strap."

Remaining portion of Shipping Strap

4.Wrap the drain hose to the laundry tub leg or standpipe with the tie strap. Push fastener into the nearest hole in the shipping strap. (See illustration 1 or 2.)

If the washer faucets and the drain standpipe are recessed, put the hooked end of the drain hose in the standpipe. Tightly wrap the tie strap around the water inlet hoses and the drain hose. (See illustration 3.)

NOTE: If the coin slide mechanism has already been installed, skip this step and proceed to "Adjusting Coin Box."

Install Coin Slide

1.Remove the access panel from the top of the meter case by unlocking the service lock with the key shipped inside the parts bag found in the washer basket.

2.Deposit coins in coin slide and push coin slide all the way in. Hold coin slide in extended position and insert through opening in the front of the meter case.

3.From inside the meter case, place the threaded end of the bolt through the center mounting hole in the front of the meter case.

4.While holding the bolt in place, guide the coin slide mechanism onto the threads and into the guide holes in the front of the meter case.

5.Tighten the bolt as you guide the coin slide mechanism into place.