Important Safety Instructions, Parts supplied

IMPORTANT SAFETY INSTRUCTIONS

WARNING: To reduce the risk of fire, electric shock, or injuryto persons when using the washer, follow basic precautions, including the following:

•Read all instructions before using the washer.

•Do not wash articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaning solvents, other flammable, or explosive substances as they give off vapors that could ignite or explode.

•Do not add gasoline, dry-cleaning solvents, or other flammable, or explosive substances to the wash water. These substances give off vapors that could ignite or explode.

•Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for 2 weeks or more. HYDROGEN GAS IS

EXPLOSIVE. If the hot water system has not been used for such a period, before using the washing machine, turn on all hot water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.

•Do not allow children to play on or in the washer. Close supervision of children is necessary when the washer is used near children.

•Before the washer is removed from service or discarded, remove the door or lid.

•Do not reach into the washer if the drum, tub or agitator is moving.

•Do not install or store the washer where it will be exposed to the weather.

•Do not tamper with controls.

•Do not repair or replace any part of the washer or attempt any servicing unless specifically recommended in this manual or in published user-repair instructions that you understand and have the skills to carry out.

•See "Electrical Requirements" for grounding instructions.

SAVE TNESEINSTRUCTIONS

INSTALLATION REQUIREMENTS

Assemble the necessary tools and supplies before beginning the washer installation, The parts supplied are in the washer basket.

Tools needed for connecting the drain hose and water inlet hoses:

•Pliers that open to 19/16in. (3.95 cm)

•Flashlight (optional)

Parts supplied:

Tools needed for securing the drain hose and leveling the washer:

•Adjustable or open end wrench 9/lein. (14 mm)

•Level

•Wood block

•Ruler or measuring tape

Parts supplied:

1. Shipping strap with fastener

2. Front leveling feet with nuts (2)

1.Drain hose

2.Silver, double-wire hose clamp (for the bottom of the drain hose)

3.Yellow, single-wire hose clamp (for the top of the drain hose)

4.Water inlet hoses (2)

5.Flat water inlet hose washers (4)

Tools needed for installing coin slide mechanism and removing/replacing cabinet:

•Ratchet wrench and a %8in. (8 mm) socket

•Regular screwdriver

•#2 Phillips screwdriver