6.
1 | Coin | Box | 3 | Access |
2 | Coin | Slide | 4 | Meter Case |
4.TiltthewasherbackandremovethewoodblockGently.
lowerthewashertothefloor.
5.Slide to final location.
6.Tilt the washer forward until the rear of the washer is at least
4 in. (10.2 cm) off the floor. You may hear the
7.Check the levelness of the washer by placing a level on the top edges of the washer, first
8.If the washer is not level, move the washer out slightly, tip back, prop up the front of the washer with the wood block and adjust the feet up or down as necessary. Repeat steps 5 through 8 until washer is level.
Adjusting Coin Box
1.Insert the coin box into the meter case from the front. The tight fit of the coin box is set at the factory. You can loosen the fit as desired by loosening the slotted rods inside the front of the coin box.
9.After the washer is in the final location and level, use a %e in. (14 mm)
If the nuts are not tight against the washer cabinet, the washer may vibrate.
2
! & 2 Slotted Rods
NOTE: Keep a record of all coin box key numbers. A lost key can only be replaced if ordered by key number from Sears Parts. The key number is located on the key. If the key number is not available, the lock must be drilled out to remove the coin box.
2.Replace the meter case access panel.
Properly leveling your washer prevents excessive noise and vibration.
Install the front leveling feet
1.Prop up the front of the washer about 4 in. (10.2 cm) with a wood block or similar object. The block needs to support the weight of the washer.
2.Screw the lock nut onto each foot to within 1 in. (2.5 cm) of the base.
(2.5 cm)
3.Screw the feet into the correct holes at the front corner of the washer until the nuts touch the washer.
NOTE: Do not tighten the nuts until the washer is level.
t.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. (See "Electrical Requirements.")
2.Check to be sure all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
3.Check to be sure you have all of your tools.
4.Check to be sure that the yellow shipping strap was removed from the back of the washer and used to secure the drain hose.
5.Dispose/recycle all packaging materials.
6.Check to be sure the water faucets are on.
7.Check for leaks around faucets and inlet hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
8.Plug into a grounded 3 prong outlet.
9.Remove the protective film on the console and any tape remaining on the washer.
8