Samsung WE357A7L, WE357A7W, WE357A7S, WE357A7G, WE357A7R, SK-3A1, SK-4A, SK-XAA user manual Cold Hot

Page 10

installing your washer

2.Insert new rubber washer (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings.

3.Check the inlet hose to ensure a washer is inside each fill hose.

Thread the inlet hoses to the HOT and COLD faucet connections.

On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers.

Cold

Hot

Rubber washer

For correct water use, connect both HOT and COLD water valves. If one is not connected, an “nF” (no fill) error can occur.

4.Turn on the “HOT” and “COLD “water supply and check all connections at the water valve and the faucet for leaks.

Cold printed Hot printed

5.Plug the power cord into a 3-Prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker.

Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded receptacle.

6.Slide your washer into position.

7.Level your washer by turning the leveling legs in or out as necessary by hand or wrench included with your washer. When your washer is level, tighten the nuts using the wrench or (-) driver.

Your Washer must be leveled on all four sides. A carpenter’s level should be used on all four corners of your Washer. It’s a good idea after the first dozen washes to recheck your washer’s levelness.

10_ Installing your washer

Image 10
Contents Washing Machine High Efficiency Energy & Water Saving SilverCare SanitizationExtra Large Capacity Direct Drive Inverter MotorSafety information Safety informationSafety information Contents Overview of Your Washer Installing your washerUnpacking Your Washer Basic Location RequirementsWater GroundingDrain facility Flooring Alcove or closet installationLocation considerations Important Note to Installer StepCold Hot Loading Your Washer Operating instructionsGetting Started Washing a load of laundry Overview of the Control PanelSelect Cycle Garment+ Child lockMy cycle For Silvercare Washing Features Detergent USEPre wash compartment Cleaning the Dispensers Cleaning the ExteriorCleaning the Interior Maintaining your washerTroubleshooting Check These Points if Your WASHER…Temperature control feature as your Washer determines Code Symbol Meaning Solution Information CodesWhen it finishes washing, End Fabric Care Chart AppendixHelping the Environment SpecificationDeclaration of Conformity Cycle Chart Functions OptionsWarranty WarrantyWarranty Questions or COMMENTS?