IMPORTANT NOTE TO INSTALLER
Please read the following instructions carefully before installing your Washer. These instructions should be retained for future reference.
We recommend you hire a professional for installation of this washer.
STEP 1
Removing the Shipping Bolts
Before using your Washer, you must remove the four shipping bolts from the back of the unit.
1. Loosen all bolts with the supplied spanner.
2. Slide the bolt and spacer up and remove the bolt with the spacer through the hole in the rear wall of your washer. Repeat for each bolt.
3.Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
STEP 2
Selecting a Location
Before you install your washer, make sure the location:
•Has a hard, level surface
•Is away from direct sunlight
•Has adequate ventilation
•Will not be freezing (below 32°F or 0°C)
•Is away from heat sources such as oil or gas
•Has enough space so that your Washer need not stand on its power cord
•Doesn’t have any carpeting that will obstruct ventilation openings.
01 Installing your washer
STEP 3
Installing your Washer
1.Place the drain hose in the drain facility. Be sure an airtight connection is NOT made between the drain hose and the standpipe. The standpipe must be at least 18 in or 46 cm high.
Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way – by elbows, couplings, or excessive lengths. For situations where the drain hose cannot be conveniently elevated to at least 18 in or 46 cm, the drain hose must be supported.
Laundry tub | Stand pipe |
| Hose |
| retainer |
96” Max |
|
18” Min | 96” Max |
| |
| 18” Min |
| Tie strap |
Installing your washer _9