Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or
other injury.
NOTES:
*Do not move dryer by grasping console.
*Rough handling or moving dryer over rough floor can result in damage to leveling feet.
*Slide dryer onto cardboard or hardboard before moving across floor.
1.Open dryer and remove any shipping tape that secures the dryer drum. Remove all parts, packages, and leveling feet.
2.Move dryer close to permanent location.
3.Install leveling legs:
*Take two of the cardboard corners from the carton and place them on the floor in back of the dryer.
Firmly grasp the body of the dryer and gently lay it back on the cardboard corners.
*Check leg for diamond marking. This is how far the leg should go into the hole. Start to screw legs into holes by hand. A little liquid detergent applied to the legs will help lubricate them.
*Use a
| Cardboard |
I | corners |
I |
|
I |
|
I |
|
| Diamond |
Leveling leg
4, Level dryer:
•Stand the dryer up and move it close to its final location, Leave enough room to connect the exhaust vent.
•Check levelness of dryer by placing a level on top of the dryer, first
•If the dryer is not level, prop the dryer up using two stacked cardboard corner posts.
•Use a wrench to adjust the legs up or down until the top of the dryer is level.
12