Bosch Appliances WTZ 1295C Against Floor, If the appliance slides, it may, Cause Injury Damage

Figure 9

4.Using the 6 mm Allen (Hex)

wrench, install the socket head cap screws and flat washers (see Figure 10).

Use the wrench HANDto

d

CAUTION

TIGHTEN all screws (seeFigure

10).

Helpful

hint: Do

not

tighten any

When lifting the appliance, be

careful not to allow it to slide

screws completely until all are

against

the

floor.

started

into their

threads.

After all

screws

are

hand

tight,

use

If the appliance slides, it may

the wrench to tighten an

additional

cause

injury

or

damage.

1/3 to

1/2 turn

Figure(see

11).

6. Lift the appliance and pedestal

Note: Tightening

torque

for

the

assembly

back

to

an upright

pedestal

screws

is

a

minimum

of

position

(use of

an

assistant is

10 ft^lb

(14 N-m)

to

13

ft-lb

(18

required)

(seeFigure

13).

N-m).

d CAUTION

Insert the square spacer between
the pedestal housing and the
appliance	housing.			Holding		the
spacer in place, insert the bolt so it
passes through the flat washer,
pedestal housing, then the spacer,
and into the protruding threaded
bushing	in	the	appliance		base.			Figure	11
Repeat for		all	four	bolts.
						5.	Install the four new feet that are
Make sure the webbed side						of	included	with the	pedestal.	Screw
each spacer is down toward						the	the feet into the threaded corner
base of	the pedestal.				The	spacer	holes in	the base of the		pedestal.

should fit up against the appliance
housing. Align the outer edges of				NOTICE
the spacer with the appliance and
pedestal housings. Loosely thread
	Use		only		the	feet	supplied
all four bolts with the washers and
spacers in place before tightening	with the			pedestal.			Do not use
	the	feet		that		originally came with
any of the bolts completely.
	the	appliance.
	Using the				supplied		17 mm	open
	end wrench, tighten only the two
	rear feet locknuts against the
	pedestal			housing (seeFigure				12).

Avoid holding the appliance by the pedestal when lifting it.

To avoid damaging the pedestal do not use a dolly to lift or move the appliance once the pedestal

is installed.

Figure 13

The front two feet should be handStep 7 below applies to washers.
tightened only, so the appliance	For	dryers	go	directly	to step 8.
can be leveled later.
	7.	Remove	the	transport	bolts.

Figure 12

Figure 10

dCAUTION

To avoid possible injury and damage to the appliance and adjacent surfaces, all four transport bolts must be removed before using the appliance. Retain the bolts for use in any future transport (e.g. when moving).

qLoosen all four bolts before removing any of the bolts all the way from the unit.

qRemove the bottom two bolts prior to removing the top two bolts.

5