Electrolux 14700 VIT manual Problem

Page 39

Something not working?

Problem

The machine does not fill

The machine fills then empties immediately

The machine does not empty and/or does not spin

There is water on the floor

Possible cause	Solution

The water tap is closed (E10).	Open the water tap.
The water inlet hose is	Check the whole length of the
squashed or kinked (E10).	hose and remove the kink.
The small filter of the water	Clean the filter.
inlet hose is clogged (E10).
The door is not properly	Close the door.
closed (E40).
The end of the drain hose	Place the hose at the right
is too low.	height (see Installation
	section).

The drain hose is	Check the whole length of
squashed or kinked (E20).	the hose and remove the
	kink.
The drain filter (EF0) or the	Clean the filter or check
drain hose are clogged (E20). the hose.
The RINSE HOLD option	Empty out the water by
(stop with water in drum)	pressing the START button
has been selected.	or selecting the PUMP OUT
	programme.
The laundry is not evenly	Redistribute the laundry
distributed inside the drum.	manually in the drum.

Too much detergent has	Measure detergent
been used.	according to the
	manufacturer’s instructions.
An unsuitable detergent	Use a suitable washing
has been used that	machine detergent.
creates too much foam.
One of the connectors on	Check that the hose is
the water inlet hose is	firmly screwed on at both
leaking.	ends.
The drain filter has not	Fully screw the filter into
been properly screwed on	place.
after cleaning.

39

Image 39

Contents Lavamat 14700 VIT Turbo Dear customer Contents Programme charts Building-in Safety instructions General safetyInstallation During use Child safetyDisposal Packaging materialsMachine Tips for environmental protection Main features of your washer-dryer Front view Description of the applianceProgramme selector dial Control panelSTART/PAUSE button Delay Start buttonON/OFF button Mains-on lightProgramme Option buttons Drying Time buttonSpin Speed Programme progress display DisplayOpening the door after the programme has started Cancelling/Altering a programmeBefore the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleSynthetics Easy-cares Weight of laundryTypes of fabric and care labels CottonDelicates Which detergent? Detergents and additivesTraditional Powders Which form?Preparing the drying cycle LoadGarments not suitable for drying Drying symbols on garment labels Duration of the drying cycleFibre residue Additional drying Load the laundry How to washSwitching the machine on Max. loadSelection of the desired wash programme Selection of the Spin Speed or Rinse Hold optionSelection of the Extra Rinse option Selection of the Delay Start option If the delay start option has been selected, the machineStarting the programme How to dry At the end of the programmeDrying only NON-STOP programme Automatic washing and dryingWash programmes Programme chartTo empty press Special programmesDrying Exterior Cleaning and maintenancePeriodical cleaning After each washDoor seal Drain filterWater inlet filter Emergency emptying out Frost precautionsSomething not working? TroubleshootingProblem Noisy Feet have not been E10 White residue is left on the laundry Unsatisfactory washing resultsIf grey stains remain on the laundry Foam is still visible even after the last rinseThis appliance complies with the following EC directives Technical dataHelp us to help you Service & Spare PartsService & Spare Parts 08705 929Customer care Exclusions Standard Guarantee ConditionsEuropean Guarantee Safety instructions for the installer Instructions for installation and electrical connectionRear view Front view and side viewUnpacking InstallationLevelling PositioningWater inlet cold water connection only Water drainageDo not connect to a hot water supply Electrical connections Interest of the environmentPermanent connection Hinges Preparation and assembly of the doorBuilding-in DoorCounter-magnet Mounting the doorDrill four fixing holes see Fig. G Building-in Electrolux plc