12electrolux
3.Reduce the spin speed if needed, by pressing the relevant button.
4.Press button 8.
At the end of the programme, the door is released and can be opened. Turn the pro- gramme selector dial to O to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
Stand by : once the programme has finish- ed after a few minutes the energy saving system will be enabled. The brightness of
the display is reduced. By pressing any but- ton the appliance will come out of the ener- gy saving status.
USE - DRYING
DRYING ONLY
Warning!
The recommended load size is 3.5 kg for cottons and linen, 2 kg for synthetic items and 1.5 kg for wool.
Important! For wool items the timed drying is the only drying available (Drying Time button).
By pressing Drying Time button it is also possible to dry up to 5 kg of cot- ton items (see the «Drying Pro- gramme » table).
Warning!
The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe.
1.Load the laundry.
2.Select a spin cycle at the maximum spin speed allowed for the type of laun- dry in order to obtain the best drying performances.
3.Select the drying programme for Cot- tons, Synthetic or Wool in the Drying sector of the programme selector dial.
4.If you wish to select an automatic dry- ing (for cottons and synthetic items on- ly), press the button 4 until the light cor- responding to the required dryness de- gree illuminates.
5.If you wish to select a timed drying, press the button 5 until the time you want appears on the display (see the «Drying Programme» table). Every time you press this button the drying time in- creases by 5 minutes.
Note!
The programme time will automatically increase by some minutes.
6.Press button 8 to start the programme. The time remaining is updated every minute.
7.At the end of the programme, the buz- zer sounds. Three blinking «0.00» zeros appear on the display.
During the last 10 minutes of the drying cycle the appliance performs an anti- crease phase. Through this time the door is locked. The display shows three flashing zeros «0.00».
If you wish to open the door before or during the
8.Turn the selector dial to the O position to switch the machine off.
9.Remove the laundry from the drum.
Note!
The different type of cottons (towelling, sheets, shirts, and so on) or any laundry items rolling up during the spinning phase may result in partial dryness. In the excep- tional case that at the end of the cycle the laundry remains slightly wet, we suggest that you unfold the rolled up items, redis- tribute them evenly in the drum and select an additional drying cycle of
Important!