28electrolux
The rubber feet are particularly recommen- ded on floating, slippery and wooden floors. Mount the rubber feet to prevent vibration, noises and displacement of the appliance during operation.
Read carefully the instructions supplied with the kit.
WATER INLET
An inlet hose is supplied and can been found inside the machine drum. Do not use the hose from your previous machine to connect to the water supply.
Important! This appliance must be con- nected to a cold water supply.
1.Open the porthole and extract the inlet hose.
2.Connect the hose with the angled con- nection to the machine. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.
45° 35°
4.Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance.
The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
WATER-STOP DEVICE
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window «A». Should this occur, turn the water tap off and refer to your Service Cen- tre to replace the hose.
3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
A
WATER DRAINAGE
The end of the drain hose can be posi- tioned in three ways.
• Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the ma-