Cleaning the Water Inlet Filters

22electrolux

7.Remove fluff and objects from the pump.

8.Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre.

9.Clean the filter under the water tap and put it back in the pump into the special guides.

10.Make sure that you tighten correctly the filter to prevent leakages.

curely re-tightened so as to stop leaks and young children being able to remove it.

If you notice that the machine is taking lon- ger to fill, check that the filter in the water inlet hose is not blocked.

1.Turn off the water tap.

2.Unscrew the water inlet hose.

3.Clean the filter in the hose using a hard bristle brush.

4.Screw the hose back onto the tap.

5.Unscrew the hose from the machine. Keep a rug nearby because some wa- ter may flow.

6.Clean the filter in the valve with a stiff brush or with the piece of cloth.

1 2

11. Close the drain pump door.

Warning!

Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When refitting the pump cover, ensure it is se-

7.Screw the hose back to the machine and make sure the connection is tight.

8.Turn on the water tap.

EMERGENCY EMPTYING OUT

If the appliance cannot drain the water, pro- ceed as follows to empty out the machine:

1.pull out the plug from the power sock- et;

2.close the water tap;

3.if necessary, wait until the water has cooled down;

4.open the pump door;

5.place a container on the floor below the recess of the drain pump;