Maytag MAF 9801 manual Ternative, Celsius or Fahrenheit

Page 30

CELSIUS OR FAHRENHEIT

The temperature is shown in the display either in degrees Celsius or in degrees Fahrenheit.

You can change between Celsius and Fahren-

heit as follows:
Turn off the main power switch	and

then turn it on again so that the machine is in stand-by mode.

Press the	Enter button five times, and then
press the P2	button five times. These ten pres-

ses must be completed within 15 seconds. Within three seconds after pressing the P2

button for the last time, you must then use the buttons to index to your desired al-

ternative.

RESET PROGRAMME

If you wish to revert to the settings which a pre- set programme had at the time when the dryer was supplied, you can reset the programme.

1.Hold down the programme button (P1-P4) for the programme that you wish to reset.

2.Press the Enter button once.

3.Release the programme button.

The programme for the button concerned will now have reverted to its settings at the time when the dryer was supplied.

30

Image 30

Contents Maytag Contents Washer Door Before Washing the First TimeTransport Supports Check Hardness of the WaterOverfill Protection Safety InstructionsGeneral Interrupting a ProgrammeTRANSPORT/ Winter Storage DisposalChildrens Safety CHILD-SAFE WashingProtect Children Parts of the Washing Machine Detergent CompartmentPanel LC-DISPLAYBefore Washing Minimizing Allergy Hazards High Water LevelAvoid Creases Washing Save TimeDetergents Textile DyeingWashing Time Washing Washing with Easy Control1SORT the Washing 3O P E N T H E D O O R a N D P U T I N T H E Washing4PUTTING in the Washing and DETER- Gent Button 6TEMPORARY Alteration of TEMPERA- Ture and Spin SpeedProgramme with the Button During the Programme9WHEN Washing is Finished 8PROGRAMME CompletedDelayed Start 1-24 Hours Temporary Spinning or RinsingConsumption Values PRE-SET Programmes Making OWN Washing Programmes Available Settings and Options Create Your OWN Washing Programme TIPInterrupt Input Reset Programme Pre Available Types of ProgrammeMenu System for Changing a Preset Programme Select High water levelThis page has been left blank for technical printing reasons Care and Cleaning Cleaning the Detergent CompartmentCleaning the Outside of the Machine Cleaning Holes Under the Ridges Hard WaterDoor will not Open Trouble ShootingFault Indications Machine will not StartWash motor fault. Phone Service Wrong Language on the DisplayTernative Celsius or FahrenheitTechnical Data Technical InformationStandard Tests This page has been left blank for technical printing reasons Service and Guarantee ServiceGuarantee Quick Guide WashingIndex Chapter