Zanussi Washer Dryer Ance performs only a cooling phase, Drying programme, Fluff in the garments

Page 17

During the last minutes of the drying cycle the appliance performs an anti-crease phase. Through this time the door is locked. The display shows the blinking . At the end of the anti-crease phase the door pilot light 9 is off.

If you wish to open the door before or dur- ing the anti-crease phase or to interrupt it, press any button or turn the programme selec- tor dial to any programme position (except ).

7.Turn the selector dial to the position to switch the machine off.

8.Remove the laundry from the drum.

The different type of cottons (towelling, sheets, shirts, and so on) or any laundry

items rolling up during the spinning phase may result in partial dryness. In the exceptional case that at the end of the cycle the laundry remains slightly wet, we suggest that you unfold the rol- led up items, redistribute them evenly in the drum and select an additional drying cycle of 20-30 minutes.

If you set only 10 minutes of drying phase with the drying time button (5), the appli-

ance performs only a cooling phase.

NON-STOP programme - Washing and Timed Drying

The recommended load size is 3 kg for cotton and 2 kg for synthetic.

It is also possible to dry up to 4 kg of cot- ton items (see the «Drying Programme »

table).

Caution! Do not use a dosing device/ ball when carrying out a washing and

drying programme.

1.Load the laundry and add detergent and fabric softener.

2.Switch the machine on by turning the se- lector dial to the set washing programme/ fabric.

3.Select the required options by pressing the relevant buttons.

www.zanussi.com

If possible, do not select a spin speed lower than that proposed by

the appliance to avoid too long a drying time therefore saving energy.

In any case the reduction of the spin speed is only possible after selecting drying.

The lowest values you can select are 900 r.p.m. for cottons and synthetics and 700 r.p.m. for delicate fabrics.

4.Set the drying time by pressing button 5. The display shows the whole duration of the washing and the set drying cycle.

If you set a washing programme and only 10 minutes of drying cycle, the total dura-

tion displayed includes also the unrolling and the cooling phase.

5.Start the programme by pressing button 7. The time remaining is updated every minute on the display.

6.At the end of the programme turn the se-

lector dial to the position to switch the machine off and remove the laundry.

Fluff in the garments

During the WASHING AND/OR DRYING PHASE, certain types of fabric, as sponge- cloth, wool, sweatshirt, could release fluff.

The released fluff could stick to the fabrics dur- ing the next cycle.

This drawback increases with technical fabrics. To prevent the lint in your clothes, it is recom- mended:

To do not wash dark fabrics after you wash- ed and dried light colored fabrics (new sponge, wool, sweatshirt especially) and vice versa.

To air-dry this type of fabrics when they are washed the first time.

To clean the filter.

Perform one or more rinse cycles to wash the drum between the washing and drying of fabrics with different colors.

After the drying phase, thoroughly clean the empty drum, the gasket and the door with a wet rag.

17

Image 17
Contents Washer Dryer ZWT 71201 WA Contents Safety informationInstallation Safety instructionsRemove all the packaging and the transit bolts Electrical connectionWater connection Care and CleaningUse DisposalProduct description Child safetyDetergent dispenser drawer Control panelCompartment for liquid additives fabric softener, starch Bers on the following pagesSpin Delay StartRinse hold EcoDuration of the selected programme Display shows the following informationFor white and coloured cotton normally soiled Washing programmesCottons Helpful hints and tips Drying ProgrammesDrying Hints Personalisation First useLoad the laundry Daily UseMeasure out the detergent and the fabric softener Close the drawer gentlySelect the available options by means of buttons 3, 4 Select the Delay Start by pressing buttonStart the programme by pressing button Altering an option or a running programmeUse Drying NON-STOP programme Washing and Timed Drying Ance performs only a cooling phaseDrying programme Fluff in the garmentsCare and cleaning Cleaning the water inlet filters Clean the filter under a tap, to remove any traces of fluffWhat to do if… Frost precautionTurn on the water tap Turn off the water tap Unscrew the inlet hoseProblem Replace it with a new one Technical data Bient temperature InstallationConsumption values UnpackingWater inlet Raising the appliancePositioning Into a drainage standpipe This appliance must be connected to a cold water supplyWater drainage Interest of the environment Drain hose may be extended to a maxiOnto a sink outlet spigot 416 22±1,5 595-598 Building35 Ø 12,5-14 depth Hinges DoorCounter-magnet Mounting the door100 Graphic F600-605 490Environment concerns Electrical connectionChine Packaging materials132927931-A-462012