•Screw the hose back to the machine and make sure the connection is tight.
•Turn on the water tap.
Frost precaution
If the machine is exposed to temperatures be- low 0°C, certain precautions should be taken.
•Turn off the water tap.
•Unscrew the inlet hose.
•Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out.
•Screw the water inlet hose back on and re- position the emergency emptying hose after having put the cap on again.
•When you intend to start the machine up again, make sure that the room temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as fol- lows to empty out the machine:
•pull out the plug from the power socket;
•close the water tap;
What to do if…
•if necessary, wait until the water has cooled down;
•open the pump door;
•place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out;
•clean the pump if necessary as previously described;
•replace the emergency emptying hose in its seat after having plugged it;
•screw the pump cover again and close the door.
Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO Valve device avoiding that part of the detergent remains unused at next washing.
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of button 7 blinks, one of the fol- lowing alarm codes appears on the display and some acoustic signals sound every 20 seconds to indicate that the machine is not working:
• : problem with the water supply.
• : problem with the water draining.
• : door open.
Once the problem has been eliminated, press the button 7 to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
20 | www.zanussi.com |