Zanussi Washer Dryer user manual Safety instructions, Installation, Electrical connection

Page 3

Do not change the specification of this appliance.

Obey the maximum load volume of 8 kg (refer to the “Programme chart” chapter).

If the supply cord is damaged, it must be replaced by the manu- facturer, its service agent or similarly qualified persons in order to avoid a hazard.

The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa)

The ventilation openings in the base (if applicable) must not be obstructed by a carpet.

The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.

Safety instructions

Installation

Remove all the packaging and the transit bolts.

Keep the transit bolts. When you move the appliance again you must block the drum.

Do not install or use a damaged appliance.

Do not install or use the appliance where the temperature is less than 0 °C or where it is exposed to the weather.

Obey the installation instruction supplied with the appliance.

Make sure that the floor where you install the appliance is flat, stable, heat resistant and clean.

Do not install the appliance where the appli- ance door can not be fully opened.

Always be careful when you move the appli- ance because it is heavy. Always wear safety gloves.

Make sure that there is air circulation be- tween the appliance and the floor.

Adjust the feet to have the necessary space between the appliance and the carpet.

Electrical connection

Warning! Risk of fire and electrical shock.

The appliance must be earthed.

Make sure that the electrical information on the rating plate agrees with the power sup- ply. If not, contact an electrician.

Always use a correctly installed shockproof socket.

Do not use multi-plug adapters and exten- sion cables.

Make sure not to cause damage to the mains plug and to the mains cable. Should the ap- pliance power supply cable need to be re- placed, this must be carried out by our Serv- ice Centre.

Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation.

Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.

Do not touch the mains cable or the mains plug with wet hands.

Only for UK and Ireland. The appliance has a 13 amp mains plug. If it is necessary to

www.zanussi.com

3

 

Image 3
Contents Washer Dryer ZWT 71201 WA Contents Safety informationElectrical connection Safety instructionsInstallation Remove all the packaging and the transit boltsDisposal Care and CleaningWater connection UseProduct description Child safetyBers on the following pages Control panelDetergent dispenser drawer Compartment for liquid additives fabric softener, starchEco Delay StartSpin Rinse holdDuration of the selected programme Display shows the following informationFor white and coloured cotton normally soiled Washing programmesCottons Helpful hints and tips Drying ProgrammesDrying Hints Personalisation First useClose the drawer gently Daily UseLoad the laundry Measure out the detergent and the fabric softenerAltering an option or a running programme Select the Delay Start by pressing buttonSelect the available options by means of buttons 3, 4 Start the programme by pressing buttonUse Drying Fluff in the garments Ance performs only a cooling phaseNON-STOP programme Washing and Timed Drying Drying programmeCare and cleaning Cleaning the water inlet filters Clean the filter under a tap, to remove any traces of fluffTurn off the water tap Unscrew the inlet hose Frost precautionWhat to do if… Turn on the water tapProblem Replace it with a new one Technical data Unpacking InstallationBient temperature Consumption valuesRaising the appliance PositioningWater inlet This appliance must be connected to a cold water supply Water drainageInto a drainage standpipe Drain hose may be extended to a maxi Onto a sink outlet spigotInterest of the environment Building 35 Ø 12,5-14 depth416 22±1,5 595-598 Mounting the door DoorHinges Counter-magnet490 Graphic F100 600-605Packaging materials Electrical connectionEnvironment concerns Chine132927931-A-462012