Zanussi Washer Dryer user manual Door, Hinges, Counter-magnet, Mounting the door

•a) Door

The dimensions of the door should be:

-width 595-598 mm

-thickness 16-22 mm

The height (C-Fig. C) depends on the height of the adjacent furniture's base.

•b) Hinges

To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 12.5-14 mm depending on the depth of door furniture) on the inner side of the door. The distance be- tween the holes hobs fixing centres must be 416 mm.

The distance (B) from upper edge of the door to the centre of the hole depends on the ad- jacent furniture's dimensions.

Caution! Do not remove the screw 8!

d) Counter-magnet (6)

The appliance is prearranged for a magnetic closure of the door.

To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D).

The required dimensions are given in the pic- ture C.

The hinges will be fixed to the door by means of screws for wood (2-Fig. B) supplied with the appliance.

4 5

6

1

•c) Mounting the door

Fix the hinges (1) to the machine by means of the M 5x15 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door.

To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

4

6

8

D

www.zanussi.com

7 3

E 8 2

Caution! Do not remove the screw 8!

If the door has to be opened from left to right, invert the position of the plates (7), the mag- net (4) and the plate (5) (Fig. B and E).

Mount the counter-magnet (6) and the hinges

(1) as previously described.

Recommendations regarding the con- struction and fitting of a base when the installation requires an integrated appli- ance to be raised.

29