to the appliance. This function remains enabled also when the washing machine is not working. There are two different ways to set this option:
1.Before pressing button 7: it will be impos- sible to start the machine.
2.After pressing button 7: it will be impossi- ble to change any other programme or op- tion.
To enable or disable this option press simulta- neously for about 6 seconds buttons 2 and 3 until on the display, the icon appears or dis- appears.
Daily Use
Load the laundry
Open the door by carefully pulling the door handle out- wards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door.
Make sure that no laundry stays be- tween the seal and the door. There is a risk of water leakage or damage to the laundry.
Measure out the detergent and the fabric softener
14
Pull out the dispenser drawer until it stops. Measure out the amount of detergent re- quired, pour it into the main wash compart- ment or in the appropriate compartment if the selected programme/option it requires (see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the com- partment marked (the amount used must not exceed the «MAX» mark in the drawer).
Close the drawer gently.
Select the required programme by means of the programme selector dial (1)
Turn the programme selector dial to the re- quired programme.
The green pilot light of button 7 starts to flash. The selector dial can be turned either clockwise or anticlockwise.
Turn the selector dial to position to reset the programme/to switch the machine OFF.
At the end of the programme the selector dial must be turned to position , to switch the machine off.
Important! If you turn the programme selector dial to another programme when the machine is working, the red pilot light of button 7 will blink 3 times and the messageErr is displayed to indicate a wrong selection. The machine will not perform the new selected programme.
Select the spin speed by pressing button 2
When selecting a programme, the appliance proposes automatically the maximum spin speed provided for that programme. (See
www.zanussi.com