Henny Penny 600, 500 warranty Error Codes, Error Code Table, Display Cause Panel Board Correction

			Model 500/600
5-2.	ERROR CODES		This section provides error codes and their
			information in the form of an easy-to-read table.
			If a problem occurs during the first operation of a
			new fryer, recheck the Installation Section .
5-3.	ERROR CODE TABLE		In the event of a control system failure, the digital
			display shows an error message coded as follows:
			“E-4”, “E-5”, “E-6”, “E-10”, “E-15”,
			“E-20-A, B, D”, “E-41”, “E-46”, & “E-70.
			An alarm sounds when an error code is displayed,
			and to silence this alarm, press any button.
	DISPLAY	CAUSE	PANEL BOARD CORRECTION
“E-4”		Control board	Turn switch to OFF position, then turn switch back to ON;
“CPU TOO		overheating	if display shows “E-4”, the control board is getting too hot;
	HOT”		check the louvers on each side of the unit for obstructions;
			check cooling fan, if present
“E-5” “OIL		Shortening	Turn switch to OFF position, then turn switch back to ON; if
TOO HOT”		overheating	display shows “E-5”, the heating circuits and temperature
			probe should be checked
“E-6A”		Temperature	Turn switch to OFF position; then turn switch back to ON; if
“OIL PROB		probe open	display shows “E-6”, have the temperature probe checked
	OPEN”
“E-6B”		Temperature	Turn switch to OFF position, then turn switch back to ON; if
“OIL PROB		probe shorted	display shows “E-6”, have the temperature probe checked
	SHRT”
“E-10”		Highlimit	Reset the high limit by manually pushing up on the reset
“HIGH			button; if high limit does not reset, high limit must be
	LMT TRIP”		replaced

5-2 1207