Manuals / Henny Penny / Kitchen Appliance / Fryer

Henny Penny 500, 600 warranty Do Not Store Or Use Gasoline Or Other Flammable Vapors

Models: 500 600

1 66

Download 66 pages 6.22 Kb

Page 5

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS

Model 500/600

This manual should be retained in a convenient location for future reference.

A wiring diagram for this appliance is located on the rear shroud cover of the control panel.

Post in a prominent location, instructions to be followed if user smells gas. This information should be obtained by consulting the local gas supplier.

Do not obstruct the flow of combustion and ventilation air.Adequate clearance must be left all around appliance for sufficient air to the combustion chamber.

The Model 600 Fryer is equipped with a continuous pilot. But Fryer can not be operated without electric power. Fryer will automatically return to normal operation when power is restored.

Keep appliance area free and clear from combustibles.

Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Read the installation, operating, and maintenance instructions thoroughly before installing or servicing this equipment.

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS

AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. FIRE OR EXPLOSION COULD RESULT.

803

Image 5

Henny Penny 500, 600 warranty Do Not Store Or Use Gasoline Or Other Flammable Vapors

Contents

Henny Penny Pressure Fryers Model Model Computron 2000 Controls OPERATOR’S MANUALPage FM07-219-B Revised LIMITED WARRANTY FOR HENNY PENNY EQUIPMENTModel 500/600 Page DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS Technical Data for CE Marked Products Page TABLE OF CONTENTSSection Section 4. PROGRAMMING TABLE OF CONTENTS ContinuedSection 5. TROUBLESHOOTING 1-3. ASSISTANCE 1-4. MODEL VARIATIONS SECTION 1. INTRODUCTION1-1. PRESSURE FRYER P-H-T Pressure Heat Time 1-2. PROPER CARE CAUTION used with the safety alert symbol indicates a 1-5. SAFETYpotentially hazardous situation which, if not avoided may result in minor or moderate injurySECTION 2. INSTALLATION 2-2. UNPACKING INSTRUCTIONS Continued 2-3. SELECTING THE FRYER position and install fryer to prevent tipping or moveLOCATION ment. Restraining ties may be used for stabilizationVentilation must conform to local, state, and national codes 2-6. GAS SUPPLY 2-7. GAS PIPING Henny Penny Part No. 19921, which complies with 1207 2-7. GAS PIPING ContinuedModel 500/600 The gas pressure regulator on the automatic gas valve 2-10. GAS PILOT & BURNER 7. Turn main power switch to ON position 2-13. ELECTRICAL REQUIREMENTS ELECTRIC FRYER GAS FRYER 2-14. ELECTRICALREQUIREMENTS 2-17. OPERATIONAL CHECKS 2-15. CHECKING THE FILTER PUMP Step 2-16. MOTOR BEARINGSPage SECTION 3. OPERATING INSTRUCTIONS Figure 1 Control Panel 3-1. OPERATING CONTROLS ContinuedModel 500/600 1207Item 3-2. OPERATING COMPONENTSDescription Function3-2. OPERATING COMPONENTS DO NOT OPEN THE DRAIN VALVE WHILE FRYPOT A microswitch that provides protection for the frypot in the event anContinued 3-2. OPERATING COMPONENTSDescription Function3-2. OPERATING COMPONENTS Continued ELECTRIC MODEL Figure 2. Operating ControlsModel 500/600 12073-2. OPERATING COMPONENTS Continued GAS MODEL Figure 3. Operating ControlsModel 500/600 1207Model 500/600 3-2. OPERATING COMPONENTS ContinuedFigure 5. Operating Controls Figure 4. Operating Controls Figure 6. Operating Controls3-3. FILLING OR ADDING SHORTENING 3-4. CARE OF THE SHORTENING FOLLOW THE INSTRUCTIONS BELOW TO AVOID 1. Be sure the drain valve is in the closed position 3-5. BASIC OPERATIONS AND PROCEDURES Continued Step Step LID WHEN THE FRYPOT IS PRESSURIZED ALLOWS WHEN FRYER IS UNDER PRESSURE. DO NOTDO NOT ATTEMPT TO OPEN LID UNTIL THE PRESSURE DROPS TO ZERO. LID IS LOCKEDFrequency 3-6. REGULAR MAINTENANCE SCHEDULE Procedure3-7. FILTER PUMP MOTOR PROTECTOR- MANUAL RESET 3-8. FILTERING OF SHORTENING Step Step 3-8. FILTERING OF SHORTENING Continued 3-8. FILTERING OF SHORTENING Continued Step 7b Step 7c Step 7f When bubbling occurs, immediately close the filter valve. This prevents aeration of the shortening, therefore increasing shortening life 3-9. FILTER PUMP PROBLEM PREVENTION 6. Unthread the suction standpipe from the screen assembly 10. Fold the corners in and then double fold the open end 3-11. CLEANING THE FRYPOT 3-11. CLEANING THE FRYPOT Continued DEADWEIGHTASSEMBLY cleaned as follows TIONS FOR OPTIONAL DIRECT-CONNECT SHORTENING SYSTEM 3-13. OPERATING INSTRUCReversing the lid gasket helps to prevent early failure of lid gasket 3-14. REVERSING THELID GASKET and the loss of pressure during a cook cycle3-15. LID LUBRICATION 3-16. LIMIT STOP ADJUSTMENT Step Step 3-17. CLEANING THE SAFETY RELIEF VALVE 3-16. LIMIT STOP ADJUSTMENT Continued3-18. CHECK & TIGHTEN ELEMENT SPREADER BARS Model 500 only To Change Set-Point Temperatures SECTION 4. PROGRAMMING4-1. INTRODUCTION 4-2 TIME AND SET-POINT PROGRAMMING To change Product Cooking TimesMODE Inputs Status high limit, drain switch, fan switch, module4-3. SPECIAL PROGRAM 4-3. SPECIAL PROGRAM MODE Continued 5-1. TROUBLESHOOTING GUIDE SECTION 5. TROUBLESHOOTINGProblem CauseERROR CODE TABLE ERROR CODESDISPLAY CAUSEContinued 3-2. ERROR CODE TABLEDISPLAY CAUSEModel 500/600 GLOSSARYgas fryers only gas fryers onlygas fryers only Model 500/600level also referred to as level indictor lines have three filter screens that include a crumb catcherModel 500/600 fryers, the lid assembly includes spindlesgas fryers only gas fryers onlygas fryers only Model 500/600gas fryers only gas fryers onlyToll free in USA Henny Penny Corporation P.O.Box Eaton,OH