Haier HWM90-98 user manual Trouble-shooting answer to question, Phenomena Reason How to settle

Trouble-shooting answer to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself.

Phenomena		The reason		How to settle
The digitron displays E0.		The top lid is opened during reserve		Close the top lid.
		procedure.
The drainage cannot work, or is too slow.		Is the drain hose put down?		Put down the drain hose. Open and close the
The digitron displays E1.		Is the drain hose blocked?		top lid once.
				Clean the foreign material. Open and close
				The top Lid Once.
It stops running in midway. The digitron		The top lid is not closed.		Close the top lid.
displays E2.
The safety switch acts, and the		Are the laundries put slantingly?		Reorder the laundries. Close the top lid.
spinning cannot work. The		Is the machine slanting?		The machine will start running after 10
digitron displays E3.				seconds of being placed horizontally.
The water filling does not work, or is		Is the water tap opened, or is there water		Open the water tap. Open and close
slow. After about 15 minutes later,		supply failure?		the top lid once.
the digital displays E4.		Is the water inlet valve blocked?		Clean the water inlet valve then open
				and close the top lid once.
		Is the water pressure too low?
				Open and close the top lid once.
The digitron displays E6.		The water level sensor is bad.		Please contact the after-sales
				service department.
The digitron displays E8.		The power voltage is too low.		Pull off the power plug. Wait for the
The digitron displays E9.		The power voltage is too high.		voltage resuming normal before usage.
		Is there power failure?		Please use it when there's power supply.
	Not wash	Is the power plug inserted tightly?		Insert the power plug tightly.
The machine does		Is the water level reached preset position?		Fill water to the preset position.
not act		Is the power plug inserted tightly?		Insert the power plug tightly.
	Not spin	Is the top lid closed reliably?		Close the top lid.
		Are the laundries set flat?		Set the laundries flat.
There's abnormal sound		Is the machine slanting?		Adjust the machine to be even
		Are the laundries put slantingly in spinning?		Reorder the laundries and close the top lid.
inside the machine
		Are there any foreign materials?		Remove the foreign materials.
The water tap leaks		Is the screw of the jointer of water		Fasten the screw of the jointer properly.
		inlet hose loose or awry?
Common phenomena
Phenomena			Explanation
The spinning is intermittent when it starts.			Balance the laundries to avoid slanting.
The wash procedure pauses.			The cloth sensor is detecting , it will add water
			after about 48 senconds.
Select spin program, but it does not work.			The program is setting the drain time , certain
			period is needed before it starts spinning.
There may be some water flowing out of the			It is the water remained performance inspection
drain hose in the first use of the machine.			by the factory.

16