Before Usingi

How to change the direction of the drain hose

1.Lean the machine down gently with the front surface facing the ground. Loosen the eight screws by a cross screwdriver.

3.Extend the drain hose from the right side. Push the drain hose into the groove with hands.

Back

Bottom plate

Front

Soft item

2.Pull out the drain hose from the groove at the left side.

Use groove at

this side after direction changing

4.Install the bottom plate (as per indicated before), then lift the machine up gently.

Page 3

Usage of the drain hose

The drain hose shall drain smoothly 1.The height of the drain hose shall be

less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.

2.Do not ramp or press the drain hose.

4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.

3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.

5.If the extra hose is too long, cut it either at A or at B point.