Maintenance Installation | Haier XQG50-600TXB, XQG50-600SW specification

Maintenance

Installation

Connection of water inlet hose and washing machine

1. Turn of the water and electricity supply			2. Unplug the machine during cleaning and
after every wash. Open the door to pre-			maintenance. Use a soft cloth dampened with
vent the formation of moisture and odors.			soapy liquid to clean the machine case and rub-
If the washing machine is left idle for a long			ber components. Do not use corrosive or abra-
period, drain any remaining water in the			sive chemicals or solvents.
machine and replace the drainage hose.

3. Clean the detergent compartment			4. Cleaning the Filter (once a month)
regularly. For the detergent compartment
similar to figure (a), raise the compartment			Press the lower edge of the filter compartment
slightly to remove and replace after cleaning.			cover to open; (Fig1-2)
			Remove the filter by turning counterclockwise;
			(Fig3)
			Flash clean with running water;
			Filter replacement is the reverse of removal. Cau-
			tion: Attention shall be paid to ensure that the filter
			tion: Attention shall be paid to ensure that the filter
			is replaced correctly to avoid possible leakage.

Fig (a)

fig.1

fig.2

fig.3

Water drainage hose

= The height of the terminal of the water drainage hose should be between 80cm-100cm, the water drainage hose must be securely placed on the clip on the back of the washing machine.

Use the water drainage support supplied as an

accessory for proper installation of the water drain-

age hose .fix the water drainage hose support with

waterproof sring.Do not use an excessively long wa-

ter drainage hose and contract the authorized tech-

nician if the water drainage hose needs to be

extended.the water drainage hose should not be ex-

tended more than250cm.(longer extension will result

in concurrent water inflow and outflow).The diam-

eter of the extension hose should be the same as

the original hose.

caution:water drainage hose must not be immersed

in water.the original and extension hoses should be

NMMÅã UMÅã

5.To prevent block- ages to the water sup-

ply or the ingress of contaminants, clean the water inlet and in- l e t w a t e r f i l t e r regularly.

7.If the washing machine is left idle for a long period turn off the water and electricity supply and open the door slightly to prevent the formation of moisture and odors.

6.If the machine is to be moved a distance location, replace the vibration mounting locks which were re- moved during installation as shown below.

Remove the back Replace the rubber Insert the bolts.

cover. plugs.


			Replace the back
Tighten the bolts with a			Replace the back
spanner.			cover.

tightly connected .

Connection of power supply

Check the following items before connection to the power supply.

==The socket conforms to the maximun power load(The maximum current load of the socket and power supply cable should not be less than 15A)K

Power supply voltage conforms to the required value.

==The power supply socket and the plug of the washing machine compatible,if they are not com- patible ,Refer to a washing machine technician or a Haier designated service point for power cable replacement.The washing machine should be connected to an earth before use.

= Supplementary earth cable should not be necessary if the socket is connected to the earth. = Supplementary earth cable should be installed on the upper back of the washing machine andconnected to an earth if the power supply socket has no earth connection.