Installation
As shown in figure1 remove all the packing materials (including the foam base).
Fig 1
Check attachments and materials.
Name | Operational | Quality | Water | Drainage | Plastic |
Qty |
| ||||
| manual | certificate | hose | holder | plugs |
Model |
|
|
|
|
|
1 | 1 | 2 | 1 | 3 | |
==Remove the packing screws as shown in figure 2. |
|
| |||
The packing bolts protect the appliance from shock during trans- |
| ||||
portation The steps below should be followed before using the |
| ||||
appliance, |
|
|
|
|
|
1. Remove the rear panel of the washing machine; |
|
| |||
2. Remove the three packing bolts from the rear panel of the wash- |
| ||||
ing machine,the rubber hose and then the shock absorption chan- |
| ||||
nel steel; |
|
|
|
|
|
3. Reinstall the back plate; |
|
|
|
| |
4. Fill the holes left by the packing bolts with plastic plugs. |
|
| |||
(Attention: the packing bolts and rubber hose should be kept in a |
| ||||
safe place for later use) |
|
|
|
| |
|
|
|
|
| cáÖ=O |
Trouble shooting
The following circumstances do not constitute problems. Do not contact the maintenance service until the problem has been confirmed.
Problem | Possible Cause | ||
|
|
| |
| Poor connection to power supply | ||
The washing machine fails to | Power failure | ||
operate | Door is not properly closed | ||
| Machine has not been switched on | ||
|
|
| |
| Water is not turned on | ||
| Water pressure is less than 0.05MPa | ||
Washing machine does not fill | The inlet hose is kinked | ||
with water | Water supply failure | ||
| The program knob is not properly set | ||
| The door is not properly closed | ||
|
|
| |
The water supply and | == Check that the height of the water hose is below | ||
drainage do not stop | 80cm | ||
|
|
| |
Drainage failure | = Drainage hose is blocked | ||
= Drainage hose end is over 100cm above the | |||
| |||
| floor level | ||
|
| ||
Strong vibration during spin | ==Some packing fixing bolts removed | ||
Washing machine on a uneven surface | |||
| |||
|
|
| |
Operation stops before comple- | Water or electricity failure | ||
tion of the wash cycle | |||
|
| ||
===Adjusting the position of the washing machine .There are ad- justable feet under the bottom of the washing machine. Before use, the washing machine should be adjusted, as shown in figure 3, so that it is level.
cáÖ=P |
Excessive foam in the drum | = The detergent is not a low foam type |
| Excessive detergent has been used |
4 | 13 |