Safety Instructions
Operating Instructions
Troubleshooting Tips
GEAppliances.com
INSTALLING THE STACK BRACKET KIT
1.Remove the Dryer leveling legs
A. Carefully lay the dryer on its side. Use the packing material so you don’t scratch the finish on the dryer.
B.Use an
Back out and remove
all 4 leveling legs
2.Install Rubber Pads to Dryer Base
Locate the 4 rubber pads in the parts package. Remove the adhesive backing and firmly place over on the bracket where you removed the leveling legs.
Consumer Support
22
3.Install Bracket to Dryer
A.Align the holes in the left bracket with the holes in the bottom left corner of the dryer. Use a Phillips screwdriver to install the 2 #12 x 1″ tapping screws.
B.Repeat the above step with the right bracket on the bottom right corner of the dryer.
C.Set the dryer upright.
NOTE: Make sure to set the dryer on a piece of packing material so the brackets that are attached to the bottom of the dryer do not damage the floor.