Changing programme
To change a programme which has been selected by mistake once the pro- gramme has started, first turn the programme selector to OFF and then reset the programme.
The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indi- cators flash. If an option button (excluding the AUDIBLE SIGNAL button) is pressed, the corresponding indicator flashes several times. The drying pro- gramme is not however affected by this (laundry protection).
Removing laundry or loading laundry when necessary
1. Open loading door
Warning! Laundry and drum can become hot. Risk of burns!
2.Load or remove laundry items.
3.Close loading securely. Lock must audibly lock.
4.Press the START/PAUSE button to continue the drying cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, the END and CREASE GUARD dis- plays light up. If the AUDIBLE SIGNAL button has been pressed, an audible signal sounds intermittently.
The drying cycle is automatically followed by a crease guard phase which lasts around 30 minutes. The drum rotates in intervals during this phase. The laundry thereby remains relaxed and free of creases. The laundry can be removed at any time during the crease guard phase. (The laundry should be taken out towards the end of the crease guard phase at the latest to prevent creases from forming.)
1.Open loading door
2.Before removing the laundry, remove lint from the
3.Remove laundry.
4.Turn the programme selector to OFF. Important! After each drying cycle
–clean the
–drain the condensate tank
(refer to the “Cleaning and maintenance” section). 5. Close loading door.
16