Door reversal instructions

Warning! The door stop may only be changed by a specialist. If necessary,please contact our after-sales service or your specialist dealer.

Warning! Before changing the door stop, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.

1. Open loading door

2. Unscrew hinge A from the front ofthe machine and take off the loading door.

3.Remove cover plates B and C. To do this, insert a thin screwdriver into the slots as

shown in the illustration, press down- wards slightly and pry out the cover plates.

4. Use an appropriate tool and exert pres- sure to unfasten locking block D from the snap-on fixture, take out and reins- ert on the other side, having rotated the block through 180°.

5. Unscrew hinge A from the loading door, rotate through 180°, reinsert on the opposite side and screw down.

6. Reinsert cover plates B and C on the opposite site having first rotated them through 180°.

7. Unscrew cover plates E from the front of the machine, rotate through 180, screw on the opposite side.

8. Unscrew door lock F, push down slightly and remove from the front of the machine.

9. Press snap-in button G in and down, press cover down slightly and remove from front of the machine.

10. Transfer door lock F to the oppositesi- de and screw down.

11. Fix cover G on to the other side and allow the snap-in button to lock in place.

12. Insert loading door and hinges into recesses on the front of the machine and screw down.