Electrolux T57830 manual Changing bulb for inside light, Special Care

Problem	Possible cause	Remedy
	Lint filter clogged.	Clean lint filter.
	Heat exchanger clogged	Clean heat exchanger.
Drying cycle lasts an	with lint.
unusually long time.
Note:	SPECIAL CARE	SPECIAL CARE is only suita-
After around 5 hours	button pressed and load	ble for use with
the drying cycle ends	volume too big.	loads of up to 3 kg!
automatically (see
„Drying cycle complete“).	Load volume too big.	Reduce load volume.
	Laundry insufficiently pre-	Laundry must be adequately
	drained.	pre-drained.
Drying cycle ends	Not enough washing loaded	Select time programme or
shortly after programme	or washing loaded is too	higher drying level (e.g.
starts. END display illumina-		INTENSIVE DRY instead of
	dry for selected programme.
ted.		STORAGE DRY).

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The special bulb is available from the after-sales service, ET-Nr. 112 552 000-5.

Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!

Warning! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.

1.Unscrew covering bonnet from above bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw covering bonnet back down.

Warning! For reasons associated with safety, the covering bonnet must

be screwed down tightly. If this is not done, the dryer must not be operated.

23