Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).
Each time you press the button, the band changes as follows:
| FM1 |
| FM2 |
| FM3 |
| AM |
|
|
|
|
|
| ||||
| (F1) |
| (F2) |
| (F3) |
|
|
|
|
|
|
|
|
|
|
|
|
2 Tune in to a station (in this
example, of 88.3 MHz).
Press ¢ 
to tune in to stations of higher frequencies.
Press 4 
to tune in to stations of lower frequencies.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
4 Repeat the above procedure to store |
| |
ENGLISH | ||
other stations into other preset | ||
| ||
numbers. |
| |
Notes: |
|
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 8 and 9.
1 Select the band (FM1 – 3, AM).
| FM1 |
| FM2 |
| FM3 |
| AM |
|
|
|
|
|
| ||||
| (F1) |
| (F2) |
| (F3) |
|
|
|
|
|
|
|
|
|
|
|
|
2 Select the number (1 – 6) for the preset station you want.
Note:
You can also use the 5 (up) or ° (down) buttons on the unit to select the next or previous preset stations. Each time you press the 5 (up) or °(down) buttons, the next or previous preset station is tuned in.
Selected band/preset number and “MEMO” (memory) appear alternately for a while.
9