2Installation
Refer to the nearest Authorised Service Agent for installation of your product.
CPreparation of location and electrical
installation for the product is under customer’s responsibility.
BInstallation and electrical connections must
be carried out by a qualified personnel. A Prior to installation, visually check if the
product has any defects on it. If so, do not have it installed. Damaged products will cause risks for your safety.
Appropriate installation location
•Install the product in an environment which has no risk of freezing and is in a stable and level position.
•Operate your product in a well ventilated,
•Do not block the air ducts in front of and under the product with materials such as long pile rugs and wooden bands.
•Do not place your product on a long pile rug or on similar surfaces.
•Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product.
•Once the product is installed, it should stay at the same place where its connections have been made. When installing the product, make sure that the rear wall of it does not touch anywhere (tap, socket, etc.) and also pay attention to install the product at a place where it will stay permanently.
B Do not place the product on top of the power cable.
•Keep at least 1.5 cm distance to walls of other furniture.
Removing the transportation safety assembly
ARemove the transportation safety assembly before using the product for the first time.
1.Open the loading door.
2.There is a nylon bag inside the drum that contains a piece of styrofoam. Hold it from its section marked with XX.
3.Pull the nylon towards yourself and remove the transportation safety assembly.
AMake sure that you have removed the transportation safety assembly (nylon+styrofoam pieces) before using the product for the first time. Do not leave any items inside the drum.
Under counter installation
•A special part (Part no. 297 360 0100) replacing the top trim must be provided and installed by the Authorised Service Agent in order to use the machine under a counter or in a cupboard. It should never be operated without the top trim.
•Leave at least 3 cm of space between
the side and rear walls of the product and the walls of the counter/cupboard when installing your product under a counter or in a cupboard.
Mounting over a washing machine
•A fitting device should be used between the two machines when installing above a washing machine. The bracket (Part no. 297 720 0100 white/297 720 0400 grey) must be installed by the Authorised Service Agent.
•Place the product on a firm floor. If it will be placed on top of a washing machine, the approximate weight of both machines may reach 180 kg when they are full. Therefore, the floor must be capable of carrying the load on it!
Connection to water drain;
In products equipped with a condenser unit the water accumulated during the drying cycle is collected in the water tank. You should drain the accumulated water after each drying cycle.
5 EN