Beko DCU 8230 Electrical requirements, This appliance must be earthed, Fitting a different plug

Page 10

4Electrical Connection

Make sure that you have an earthed power outlet socket rated at 13 amps (minimum).

Attention!

If you use your dryer as built-in, the socket must be reachable after installation, or a separate switch (which can disconnect the two poles) must be used in the installation. Check for suitability.

For a permanent connection, a master switch with at least 3mm contact clearance and minumum 13 A rating must be used.

Electrical requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating label corresponds to your electricity supply. We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket in a readily accessible position.

Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a Authorised Service Agent.

AWarning

This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted.

The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

In order to avoid hazards, damaged supply cord should be replaced by the manufacturer, its service agent or similarly qualified people.

Built-under installation

This appliance can be installed under a worktop.

AUndercounter installation without the top cover must only be carried out by an authorised agent.Risk of electric shock.

A Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals on your plug, proceed as follows:

1 Connect the green - yellow or green (earth) wire to the terminal in the plug marked ‘E’ or with the symbol or coloured green and yellow or green.

2 Connect the blue (neutral) wire to the terminal in the plug marked ‘N’ or coloured black.

3 Connect the brown (live) wire to the terminal in the plug marked ‘L’ or coloured red.

With the alternative plugs a 13A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.

Washer/dryer combination

Do not stack washing machine on top of the tumble dryer. This would damage both appliances and guarantees would become

Green and yellow

or green

N

L

Blue or black

Brown or red

 

void. It is also unsafe to stack an appliance on top of another without using a suitable and approved stacking kit obtained from the manufacturer of the appliances.

•A special stacking kit is required as an optional extra please contact customer service.

10

EN

Page 9 Page 11
Image 10
Page 9 Page 11
Contents DCU Explanation of symbols Read this manual prior to initial operation of the productTable of Contents Overview Kick plate opening tab Fluff filter Adjustable feetYour Dryer Control panelTechnical Specifications General safety Important safety instructionsDo not use electrical devices in the product Children’s safety Intended useInstallation Disposing of packaging material Adjusting the feetFirst use Transportation of the machineThis appliance must be earthed This appliance can be installed under a worktopElectrical requirements Fitting a different plugLaundry suitable for drying in the machine Initial preparations for dryingThings to be done for energy saving Laundry unsuitable for drying in the machinePreparing laundry for drying Following weights are given as examplesCorrect load capacity Selecting a Programme and OperatingYour Machine Control panelPreparing the machine 1. Plug in your machine Programme selectionProgramme selection and consumption table Cottons / ColoredsStarting the programme Time delayAuxiliary function Progress of programmeAdding/removing laundry in standby mode Finishing by canceling the programmePress Start/Pause/Cancel button to start the programme Child-proof lockEnd of programme 18 ENSensor Maintenance and cleaningFilter Cartridge / Door Inner Surface Water tankFor the condenser Place the water tank into its seatSuggested solutions for problems What is not covered? GuaranteeWhat is covered? Important notes

DCU 8230 specifications

The Beko DCU 8230 is a highly efficient and innovative tumble dryer designed to simplify laundry care while ensuring optimal results. This freestanding model is particularly well-suited for consumers seeking a balance between performance, capacity, and energy efficiency.

One of the standout features of the Beko DCU 8230 is its 8 kg capacity. This spacious drum allows users to dry larger loads in a single cycle, making it an excellent option for families or anyone who regularly handles bulky items, such as bedding or towels. The dryer also incorporates a range of programs tailored to various fabric types, ensuring gentle and effective drying for everything from delicate garments to heavy duty textiles.

The dryer boasts a variety of sensor drying programs, which are equipped with advanced technology to monitor moisture levels in the drum. This allows the machine to automatically adjust the drying time, optimizing both performance and energy usage. With this feature, users can save time and reduce energy consumption, making the dryer a more environmentally friendly choice.

In terms of energy efficiency, the Beko DCU 8230 is rated as class B. This classification signifies that while the dryer may not be the absolute most efficient, it still performs well in minimizing energy use. It also features an easy-to-empty condenser tank, which collects moisture during the drying process and eliminates the need for external venting. This makes it a versatile option for homes where venting may not be practical.

Another notable characteristic of the Beko DCU 8230 is its user-friendly interface. The control panel includes a clear display, helping users easily navigate through the various settings. Additionally, the dryer runs quietly, ensuring minimal disruption in the home environment.

Overall, with its combination of capacity, advanced technology, and energy-efficient design, the Beko DCU 8230 is an excellent choice for those seeking a reliable and effective tumble dryer. Its innovative features not only streamline the drying process but also contribute to a more environmentally conscious approach to household laundry.
Top Page Image Contents