Buhler 2895 manual Electrocution Hazard

Page 11

bühler

Allied Front-End Loader

The following pictorials indicate important precautions to be used during the operation of the loader.

DANGER

ELECTROCUTION HAZARD

To prevent serious injury or death:

Stay away from power lines and cables.

Electrocution can occur with or without direct contact.

WARNING

CRUSHING HAZARD

To prevent serious injury of death:

Do not handle round bales or other shiftable objects unless loader is equipped with an attachment designed for this purpose.

Do not handle loose loads that are not secured. Do not lift load higher than necessary.

WARNING

FALLING HAZARD

To prevent serious injury or death:

Do not lift, carry or allow anyone to ride on or work from any

portion of loader.

WARNING

HIGH PRESSURE FLUID

To prevent serious injury or death:

Relieve pressure on system before repairing or adjusting or disconnecting.

Wear proper hand and eye protection when searching for leaks. Use wood or cardboard instead of hands.

Keep all components in good repair.

If hydraulic fluid penetrates skin, obtain medical treatment IMMEDIATELY.

WARNING WARNING

ROLL-OVER HAZARD

To prevent serious injury or death:

Move and turn tractor at low speed.

Carry load no higher than necessary to clear the ground when transporting.

Add wheel ballast or rear weight for stability.

Move wheels to widest possible settings to increase stability.

It is recommended the tractor be equipped with a rollover protective structure (ROPS).

CRUSHING HAZARD

To prevent serious injury or death:

Do not allow bystanders in loader work area. Lower loader to the ground before leaving seat.

Do not walk or work under raised loader. For servicing, refer to operator's manual.

Read and understand operator's manual before operating loader.

- 9 -

P4110

Image 11
Contents Page Warranty Labor Warranty ClaimsOPERATOR’S and Parts Manual BühlerIllustration TSL shown Loader SpecificationsREG TSL Introduction Serial Number here General Safety Notes SafetyBühler Allied Front-End Loader Safety Decal Location Electrocution Hazard PRE Operation Operation Bucket Backfilling or Scraping Bühler Handling bales and pallets Level indicator Grapple Installing Installing / Removing LoaderRemoving Bühler Installing / Removing Loader Attachments TSL Loader Shown LubricationGeneral Inspection MaintenanceMounting Kit Bolt Torque ChartHydraulics Bühler Cable Sleeve Jam Nut Lock Washer Screw TSL General Note and Instructions Remedy Trouble ShootingProblem Possible CauseTrouble Shooting Problem Possible Cause Remedy Parts Appendix 2895 2895 S2895 2895 S Main Frame Assembly Description 2895 2895 S 2895 2895 S Hydraulic Plumbing Assembly Bühler TSL 2895 S TSL Main Frame Assembly Item Part No Description TSL 2895 S TSL TSL 2895 S TSL Hydraulic Plumbing Assembly TSL 2895 S TSL Possible Attachment Interference S2895 and 2895 TSL TSL Cylinder AssemblyPrevailing Torque Locknuts Hydraulic Fitting TorquesPage Buhler Manufacturing a partnership