|
|
| What to do if ... |
| 21 |
|
|
|
|
|
|
|
|
|
|
|
|
| Displayed programme time | Programme time is corrected |
|
|
|
| automatically depending on | Automatic process; this is not a | |||
| changes erratically or stays un- | ||||
| type and volume of laundry | machine fault. |
| ||
| changed for a long time. | and level of dampness. |
|
|
|
|
|
|
|
| |
| Programme inactive, empty |
| Empty condensate tank, then | ||
| water tank warning led is light- | Condensate tank is full. | start programme with START | ||
| ing. |
| PAUSE button. |
| |
| Drying cycle ends shortly after | Not enough washing loaded or | Select time programme or |
| |
| washing loaded is too dry for | higher drying level (e.g. EXTRA | |||
| programme starts. | ||||
| selected programme. | DRY instead of STORAGE DRY). | |||
|
| ||||
|
| Lint filter clogged. | Clean lint filter. |
| |
|
|
|
|
|
|
|
| Fluff filter clogged. | Clean fluff filter. |
| |
| Drying cycle lasts an unusually | Load volume too big. | Reduce load volume. |
| |
| long time. Note: After around 5 |
| Laundry must be adequately | ||
| hours the drying cycle ends au- | Laundry insufficiently spun. | |||
| spun. |
| |||
| tomatically (see „Drying cycle |
|
| ||
|
|
|
|
| |
| complete ”). | Particularly high room temper- | Automatic process, there is no | ||
|
| ature. Temporary switching off | fault with the appliance. If pos- | ||
|
| of the compressor to avoid | sible, lower the room tempera- | ||
|
| overload. | ture. |
| |
|
|
|
|
|
|
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.
1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)
2.Replace defective bulb.
3.Screw cover back down.
Check the correct positioning of
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.