JVC KD-SH9105 manual Troubleshooting, Symptoms Causes Remedies

ENGLISH

TROUBLESHOOTING

What appears to be trouble is not always serious. Check the following points before calling a service

center.

			Symptoms		Causes	Remedies
	•	Sound is sometimes			You are driving on rough	Stop playback while driving on
		interrupted.			roads.	rough roads.
					Disc is scratched.	Change the disc.
					Connections are incorrect.	Check the cords and
						connections.
	•	Sound cannot be heard			The “PowerAmp” setting is set	Set it to “On” (see page 42).
		from the speakers.			to “Off.”
					Connections are incorrect.	Check the cords and
						connections.
	•	CD-R/CD-RW cannot be			Disc is inserted upside down.	Insert the disc correctly.
		played back.
					CD-R/CD-RW is not finalized.	• Insert a finalized
	•	Tracks on the CD-R/CD-RW
		cannot be skipped.				CD-R/CD-RW.
						• Finalize the CD-R/CD-RW
Playback						with the component which
						you used for recording.
	•	Disc cannot be ejected.			Disc is locked.	Unlock the disc (see page 23.)
General
	•	Disc cannot be recognized			The CD player may function	While holding	, press 0
		(“No Disc,” “Loading Error,”			incorrectly.	for more than 2 seconds to eject
		or “Eject Error” flashes).				the disc.
	•	This unit does not work at			The built-in microcomputer	Press the reset button on the
		all.			may have functioned	control panel using a ball-point
					incorrectly due to noise, etc.	pen (see page 2).
	•	When “Reset P00” to “Reset			There is something blocking	Press the reset button on the
		P44” appears on the			the control panel movement.	control panel using a ball-point
		display.				pen (see page 2). If the reset
						button does not work. Check the
						installation. (Ex. you have used a
						screws which are longer than
						specified.)
	•			(INPUT	Input level through the	Adjust the output level on the
		OVER) indicator appears			external component (LINE	external component.
		on the display.			IN) is too high.
	•	“Panel Connect Error”			The control panel is not	Remove the control panel, wipe
		appears on the display.			attached correctly and firmly.	the connectors, then attach it
						again (see page 46).
	•	SSM automatic preset			Signals are too weak.	Store stations manually.
FM/AM
		does not work.
	•	Static noise while listening			The antenna is not connected	Connect the antenna firmly.
		to the radio.			firmly.

56