JVC KD-SX875, KD-SX975 manual Maintenance, Handling CDs

Page 33

MAINTENANCE

Handling CDs

 

COMPACT

This unit has been designed only to reproduce the CDs bearing the

 

 

marks.

Other discs cannot be played back.

DIGITAL AUDIO

 

 

 

How to handle CDs

When removing a CD from its case, press down the center holder of the case and

ENGLISH

lift the CD out, holding it by the edges.

Center holder

• Always hold the CD by the edges. Do not touch its recording surface.

When storing a CD into its case, gently insert the CD around the center holder (with the printed surface facing up).

• Make sure to store CDs into the cases after use.

To keep CDs clean

A dirty CD may not play correctly. If a CD does become dirty, wipe it with a soft cloth in a straight line from center to edge.

To play new CDs

New CDs may have some rough spots around the inner and outer edges. If such a CD is used, this unit may reject the CD.

To remove these rough spots, rub the edges with a pencil or ball-point pen, etc.

Moisture condensation

Moisture may condense on the lens inside the CD player in the following cases:

• After starting the heater in the car.

• If it becomes very humid inside the car.

Should this occur, the CD player may malfunction. In this case, eject the CD and leave the unit turned on for a few hours until the moisture evaporates.

CAUTIONS:

Do not insert 8cm (3 3/16") CDs (single CDs) into the loading slot. (Such CDs cannot be ejected.)

Do not insert any CD of unusual shape – like a heart or flower; otherwise, it will cause a malfunction.

Do not expose CDs to direct sunlight or any heat source or place them in a place subject to high temperature and humidity. Do not leave them in a car.

Do not use any solvent (for example, conventional record cleaner, spray, thinner, benzine, etc.) to clean CDs.

When playing a CD-R (Recordable)

You can play back your original CD-Rs on this receiver.

Before playing back CD-Rs, read their instructions or cautions carefully.

Some CD-Rs recorded on CD recorders may not be played back on this receiver because of their disc characteristics, and of the following reasons:

Discs are dirty or scratched.

Moisture condensation occurs on the lens inside the unit.

The pickup lens inside the CD player is dirty.

Use only “finalized” CD-Rs.

CD-RWs (Rewritable) cannot be played back on this receiver.

Do not use the CD-Rs with stickers or sticking labels on the surface. They may cause malfunctions.

About mistracking:

Mistracking may result from driving on extremely rough roads. This does not damage the unit and the CD, but will be annoying.

We recommend that you stop CD play while driving on such rough roads.

33

Image 33
Contents Instructions ∂¥„ Ë´’¥How to reset your unit Contents CD Changer Operations Adjust the volume Turn on the powerAdjust the sound as you want see pages 15 Basic OperationsListening to the radio Radio OperationsSelect the band FM1, FM2, FM3 or AM Start searching a stationFM station automatic preset SSM Storing stations in memoryPress and hold both buttons for more than 2 seconds Repeat the above procedure to store other Manual presetStations into other preset numbers Select the FM1 band Tune into a station of 88.3 MHzTuning into a preset station Select the number 1 6 for the preset station you wantSelect the band FM1, FM2, FM3 or AM you want To restore the stereo effect, press the same button again When an FM stereo broadcast is hard to receiveOther convenient tuner functions Scanning broadcast stationsPlaying a CD CD OperationsOpen the control panel Insert a disc into the loading slot Close the control panel by handTo fast-forward or reverse the track Locating a track or a particular portion on a CDTo go to the next tracks or the previous tracks To go to a particular track directlySelecting CD playback modes To play back tracks at random Random PlayTo play back tracks repeatedly Repeat Play To play back only intros Intro Scan Prohibiting CD ejectionAdjusting the sound Sound AdjustmentsSelect the item you want to adjust Adjust the levelTurning on/off the Bbeii function Select the sound mode you want Using the Sound Control Memory SCMIndication For Preset values Selecting and storing the sound modesRecalling the sound modes Call up the sound mode you want to adjust Storing your own sound adjustmentsTo adjust the bass or treble level Repeat the same procedure to store other settingsOther Main Functions Setting the clockDisp To check the other information during playBasic Procedure Changing the general settings PSMPress SEL Select when the setting is complete Selecting the level display Canceling Advanced SCMTurning on/off the key-touch tone Selecting the dimmer mode only for KD-SX975Selecting the external component to use Selecting the telephone mutingHow to attach the control panel How to detach the control panelDetaching the control panel Unlock the control panelRemove the battery holder Installing the batteryPlace the battery Return the battery holderUsing the remote controller CD Changer Operations Playing CDsSelect the CD automatic changer To go to a particular disc directly Mode RND Indicator Plays at random Mode RPT Indicator Plays repeatedlyMode Indication Plays the beginnings 15 seconds Playing an external component Select the external componentPreparations Handling CDs MaintenanceSymptoms Causes Remedies TroubleshootingSpecifications FM TunerAM Tuner تﺎﻤﻴﻠﻌﺘﻟا ﻞﻴﻟد Fuse blows Sound is distortedUnit becomes hot 12V When installing the unit without using the sleeve??O?zU?Ðd?N?J? Place this unit Under the other equipment To prevent internal heat builtup inside this unit