Frigidaire FNDP15B Cu ft Washer Instructions White KIT, C4 Attaching washer mounting hardware

3.1 cu ft WASHER INSTRUCTIONS (WHITE KIT)

• WHITE KIT • WHITE KIT • WHITE KIT • WHITE KIT • WHITE KIT • WHITE KIT •

C4) Attaching washer mounting hardware

1.Use the following instructions for mounting this type of washer to the pedestal:

Remove 2 screws from service access below front panel.

2.Remove lower service access panel.

3.Remove 2 lower screws from backsheet of washer. Save screws to reinstall later.

Remove 2 screws from washer backsheet.

4. Attach each front clip to outer-most set of holes with 2 screws.

5.Insert “A” tab of each rear bracket into the middle slots on rear of pedestal. Orient bracket outward for washer mounting.

outward

“A” middle

tab slot

6.Install 2 screws through each rear bracket into aligning pedestal holes.

D4) Mounting washer

- EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the washer.

1.Using two or more persons, slightly tip the washer back and lift it onto the pedestal. Still tipped, slide the washer back against the rear brackets and gently set down the front so the appliance is between the front and rear brackets.

SLIDE BACK TIP DOWN

2.Adjust the appliance side-to-side to align its mounting holes with the pedestal’s bracket holes.

3.Reinstall backsheet screws removed earlier through each rear bracket into the base of the washer.

4.Reinstall the lower service access panel.

5.Reinstall the 2 screws removed earlier through the outer hole of each front bracket into the base of the washer.

E4) Installing or re-installing washer

1.Slide appliance/pedestal into place.

2.Check for levelness and rock all four (4) legs again. Repeat until level and solid.

3.Refer to Washer Installation Instructions for complete details on installing water, drain, or electrical.

6